On Wed, May 02, 2018 at 10:11:52PM +0200, Mathieu Malaterre wrote:
> Improve the DTS files by removing all the leading "0x" and zeros to fix the
> following dtc warnings:
>
> Warning (unit_address_format): Node /XXX unit name should not have leading
> "0x"
>
> and
>
> Warning (unit_address_format): Node /XXX unit name should not have leading 0s
>
> Converted using the following command:
>
> find . -type f \( -iname *.dts -o -iname *.dtsi \) -exec sed -i -e
> "s/@\([0-9a-fA-FxX\.;:#]\+\)\s*{/@\L\1 {/g" -e "s/@0x\(.*\) {/@\1 {/g" -e
> "s/@0\+\(.*\) {/@0\1 {/g" {} +
>
> For simplicity, two sed expressions were used to solve each warnings
> separately.
>
> To make the regex expression more robust a few other issues were resolved,
> namely setting unit-address to lower case, and adding a whitespace before the
> the opening curly brace:
>
> https://elinux.org/Device_Tree_Linux#Linux_conventions
>
> This will solve as a side effect warning:
>
> Warning (simple_bus_reg): Node /XXX@<UPPER> simple-bus unit address format
> error, expected "<lower>"
>
> This is a follow up to commit 4c9847b7375a ("dt-bindings: Remove leading 0x
> from bindings notation")
>
> Reported-by: David Daney <[email protected]>
> Suggested-by: Rob Herring <[email protected]>
> Acked-by: Krzysztof Kozlowski <[email protected]>
> Signed-off-by: Mathieu Malaterre <[email protected]>
> ---
> v2: intermediate patch contained unrelated changes. restrict to S3 and Exynos*
>
> arch/arm/boot/dts/exynos5420.dtsi | 36 ++++++++++++++++++------------------
> arch/arm/boot/dts/s3c2416.dtsi | 8 ++++----
> 2 files changed, 22 insertions(+), 22 deletions(-)
>
Thanks, applied.
Best regards,
Krzysztof
