As stated at:
http://www.sphinx-doc.org/en/master/usage/restructuredtext/basics.html#footnotes
A footnote should contain either a number, a reference or
an auto number, e. g.:
[1], [#f1] or [#].
While using [*] accidentaly works for html, it fails for other
document outputs. In particular, it causes an error with LaTeX
output, causing all books after networking to not be built.
So, replace it by a valid syntax.
Acked-by: Oliver Hartkopp <socket...@hartkopp.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab+sams...@kernel.org>
---
Documentation/networking/can.rst | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/networking/can.rst b/Documentation/networking/can.rst
index d23c51abf8c6..2fd0b51a8c52 100644
--- a/Documentation/networking/can.rst
+++ b/Documentation/networking/can.rst
@@ -164,7 +164,7 @@ The Linux network devices (by default) just can handle the
transmission and reception of media dependent frames. Due to the
arbitration on the CAN bus the transmission of a low prio CAN-ID
may be delayed by the reception of a high prio CAN frame. To
-reflect the correct [*]_ traffic on the node the loopback of the sent
+reflect the correct [#f1]_ traffic on the node the loopback of the sent
data has to be performed right after a successful transmission. If
the CAN network interface is not capable of performing the loopback for
some reason the SocketCAN core can do this task as a fallback solution.
@@ -175,7 +175,7 @@ networking behaviour for CAN applications. Due to some
requests from
the RT-SocketCAN group the loopback optionally may be disabled for each
separate socket. See sockopts from the CAN RAW sockets in
:ref:`socketcan-raw-sockets`.
-.. [*] you really like to have this when you're running analyser
+.. [#f1] you really like to have this when you're running analyser
tools like 'candump' or 'cansniffer' on the (same) node.
--
2.17.0
