On Wed, May 30, 2018 at 12:58 AM, Ray Jui <ray....@broadcom.com> wrote:
> Add PCIe legacy interrupt INTx support to the iProc PCIe driver by
> modeling it with its own IRQ domain. All 4 interrupts INTA, INTB, INTC,
> INTD share the same interrupt line connected to the GIC in the system,
> while the status of each INTx can be obtained through the INTX CSR
> register
> + while ((status = iproc_pcie_read_reg(pcie, IPROC_PCIE_INTX_CSR) &
> + SYS_RC_INTX_MASK) != 0) {
> + for_each_set_bit(bit, &status, PCI_NUM_INTX) {
> + virq = irq_find_mapping(pcie->irq_domain, bit + 1);
> + if (virq)
> + generic_handle_irq(virq);
> + else
> + dev_err(dev, "unexpected INTx%u\n", bit);
> + }
> + }
do {
status = ...;
for_each_set_bit() {
...
}
} while (status);
would look slightly better for my opinion.
--
With Best Regards,
Andy Shevchenko
