Adjust the documentation of the new SPI memory interface based driver to reflect the new drivers settings.
Signed-off-by: Frieder Schrempf <[email protected]> --- Changes in v2: ============== * Split the moving and editing of the dt-bindings in two patches .../devicetree/bindings/spi/spi-fsl-qspi.txt | 22 ++++++++++---------- 1 file changed, 11 insertions(+), 11 deletions(-) diff --git a/Documentation/devicetree/bindings/spi/spi-fsl-qspi.txt b/Documentation/devicetree/bindings/spi/spi-fsl-qspi.txt index 483e9cf..8b4eed7 100644 --- a/Documentation/devicetree/bindings/spi/spi-fsl-qspi.txt +++ b/Documentation/devicetree/bindings/spi/spi-fsl-qspi.txt @@ -3,9 +3,8 @@ Required properties: - compatible : Should be "fsl,vf610-qspi", "fsl,imx6sx-qspi", "fsl,imx7d-qspi", "fsl,imx6ul-qspi", - "fsl,ls1021a-qspi" + "fsl,ls1021a-qspi", "fsl,ls2080a-qspi" or - "fsl,ls2080a-qspi" followed by "fsl,ls1021a-qspi", "fsl,ls1043a-qspi" followed by "fsl,ls1021a-qspi" - reg : the first contains the register location and length, the second contains the memory mapping address and length @@ -15,14 +14,15 @@ Required properties: - clock-names : Should contain the name of the clocks: "qspi_en" and "qspi". Optional properties: - - fsl,qspi-has-second-chip: The controller has two buses, bus A and bus B. - Each bus can be connected with two NOR flashes. - Most of the time, each bus only has one NOR flash - connected, this is the default case. - But if there are two NOR flashes connected to the - bus, you should enable this property. - (Please check the board's schematic.) - - big-endian : That means the IP register is big endian + - big-endian : That means the IP registers format is big endian + +Required SPI slave node properties: + - reg: There are two buses (A and B) with two chip selects each. + This encodes to which bus and CS the flash is connected: + <0>: Bus A, CS 0 + <1>: Bus A, CS 1 + <2>: Bus B, CS 0 + <3>: Bus B, CS 1 Example: @@ -40,7 +40,7 @@ qspi0: quadspi@40044000 { }; }; -Example showing the usage of two SPI NOR devices: +Example showing the usage of two SPI NOR devices on bus A: &qspi2 { pinctrl-names = "default"; -- 2.7.4
