On 08/27/2018 01:52 PM, Florian Fainelli wrote:
> On 08/27/2018 01:35 PM, Andrew Lunn wrote:
>>> @@ -210,6 +228,17 @@
>>> reg = <4>;
>>> };
>>>
>>> + port@5 {
>>> + label = "sfp";
>>> + phy-mode = "sgmii";
>>> + reg = <5>;
>>> + sfp = <&sfp>;
>>> + fixed-link {
>>> + speed = <1000>;
>>> + full-duplex;
>>> + };
>>
>> Hi Florian
>>
>> You might want to add a comment about why you are using fixed-link and
>> sgmii, which seems very odd. Is it even correct?
>
> Probably not, this is kind of left over from before adding the sfp
> phandle, but if I do remove it, and I can see the DSA slave network
> device fail to initialize, likely because we destroy the PHYLINK instance.
>
> AFAIR, when we talked about this with Russell, I did not see why we had
> to comment out the following:
>
> diff --git a/net/dsa/slave.c b/net/dsa/slave.c
> index 962c4fd338ba..f3ae16dbf8d8 100644
> --- a/net/dsa/slave.c
> +++ b/net/dsa/slave.c
> @@ -1227,7 +1227,7 @@ static int dsa_slave_phy_setup(struct net_device
> *slave_dev)
> netdev_err(slave_dev,
> "failed to connect to port %d: %d\n",
> dp->index, ret);
> - phylink_destroy(dp->pl);
> + //phylink_destroy(dp->pl);
> return ret;
> }
> }
>
> maybe you know?
Stupid question, if we have a "sfp" phandle, must one also specify a
managed = "in-band-status" property? Under what circumstances are not
these two things implying one another (SFF maybe)?
That would explain why the code path taken from phylink_of_phy_connect()
would not return 0 and we would indeed fail to connect to the built-in
DSA MDIO bus.
--
Florian
