On Wed, 3 Oct 2018 09:42:14 +0800
Phil Reid <[email protected]> wrote:
> G'day Song,
Hi Phil. Good point below. One general thing though, if you
could possibly crop down a review email when you are addressing one specific
point it would be very much appreciated!
Saves everyone else scrolling and if they have a rubbish email client
missing the comment entirely!
Thanks,
>
> Noticed a one more thing below
>
...
> > +int rm3100_common_probe(struct device *dev, struct regmap *regmap, int irq)
> > +{
> > + struct iio_dev *indio_dev;
> > + struct rm3100_data *data;
> > + unsigned int tmp;
> > + int ret;
> > +
> > + indio_dev = devm_iio_device_alloc(dev, sizeof(*data));
> > + if (!indio_dev)
> > + return -ENOMEM;
> > +
> > + data = iio_priv(indio_dev);
> > + data->regmap = regmap;
> > +
> > + mutex_init(&data->lock);
> > +
> > + indio_dev->dev.parent = dev;
> > + indio_dev->name = "rm3100";
> > + indio_dev->info = &rm3100_info;
> > + indio_dev->channels = rm3100_channels;
> > + indio_dev->num_channels = ARRAY_SIZE(rm3100_channels);
> > + indio_dev->modes = INDIO_DIRECT_MODE;
> > + indio_dev->available_scan_masks = rm3100_scan_masks;
> > +
> > + if (!irq)
> > + data->use_interrupt = false;
> > + else {
> > + data->use_interrupt = true;
> > + ret = devm_request_irq(dev,
> > + irq,
> > + rm3100_irq_handler,
> > + IRQF_TRIGGER_RISING,
> > + indio_dev->name,
> > + data);
>
> Assuming the irq source is the DRDY pin, this pin is active high.
> Which is automatically cleared when reading the measurement results register.
>
> Perhaps when using interrupts the irq handler should do the read into
> data->buffer
> to clear the irq. Would need to use devm_request_threaded_irq instead.
Agreed. With a level interrupt that is the easiest way to handle it.
Grab the data in the threaded handler and complete after that.
Jonathan
>
> The SOC irq block I use doesn't support edge triggered irqs, so this
> currently wouldn't work if
> DRDY was connected to that.
>
>
> > + if (ret < 0) {
> > + dev_err(dev, "request irq line failed.\n");
> > + return ret;
> > + }
> > + init_completion(&data->measuring_done);
> > + }
> > +
> > + ret = devm_iio_triggered_buffer_setup(dev, indio_dev, NULL,
> > + rm3100_trigger_handler, NULL);
> > + if (ret < 0)
> > + return ret;
> > +
> > + ret = regmap_read(regmap, RM3100_REG_TMRC, &tmp);
> > + if (ret < 0)
> > + return ret;
> > + /* Initializing max wait time, 3sec more wait time for conversion. */
> > + data->conversion_time =
> > + rm3100_samp_rates[tmp - RM3100_TMRC_OFFSET][2] + 3000;
> > +
...
