On 31 October 2018 at 16:56, Linus Walleij <linus.wall...@linaro.org> wrote:
> On Mon, Oct 22, 2018 at 9:44 AM Baolin Wang <baolin.w...@linaro.org> wrote:
>
>> This patch adds the Spreadtrum SC27XX serial PMICs fuel gauge support,
>> which is used to calculate the battery capacity.
>>
>> Original-by: Yuanjiang Yu <yuanjiang...@unisoc.com>
>> Signed-off-by: Baolin Wang <baolin.w...@linaro.org>
>> Acked-by: Linus Walleij <linus.wall...@linaro.org>
>> ---
>> Changes from v5:
>> - Save the OCV values in micro volts for OCV capacity table.
>> - Use devm_kmemdup() instead of devm_kzalloc() in sc27xx_fgu_hw_init()
>
> Hi Baolin, you can keep my ACK, just adding some nitpicking:
Thanks.
>
>> +struct sc27xx_fgu_data {
>> + struct regmap *regmap;
>> + struct device *dev;
>> + struct power_supply *battery;
>> + u32 base;
>> + struct mutex lock;
>> + struct gpio_desc *gpiod;
>> + struct iio_channel *channel;
>> + bool bat_present;
>> + int internal_resist;
>> + int total_cap;
>> + int init_cap;
>> + int init_clbcnt;
>> + int max_volt;
>> + int table_len;
>
> Can the above really be negative or should these int:s really
> be unsigned int?
I think the table_len can be changed to u32, but for others, I'd like
to keep consistency with the power supply battery information。
>
>> +static int sc27xx_fgu_adc_to_current(int adc)
>> +{
>> + return (adc * 1000) / SC27XX_FGU_1000MA_ADC;
>> +}
>> +
>> +static int sc27xx_fgu_adc_to_voltage(int adc)
>> +{
>> + return (adc * 1000) / SC27XX_FGU_1000MV_ADC;
>> +}
>
> Would you maybe use
> DIV_ROUND_CLOSEST(adc*1000, SC27XX_FGU_1000MV_ADC)
> on these?
Good point. Will change in next version. Thanks for your comments.
>
> Overall this is a very fine driver and really pretty compared to some
> other stuff we have in drivers/power.
Thanks.
--
Baolin Wang
Best Regards
