spi_nor_read_raw() calls nor->read() which might be implemented
by the m25p80 driver. m25p80 uses the spi-mem layer which requires
DMA-able in/out buffers. Pass kmalloc'ed dma buffer to spi_nor_read_raw().

Signed-off-by: Tudor Ambarus <[email protected]>
---
 drivers/mtd/spi-nor/spi-nor.c | 14 ++++++++++----
 1 file changed, 10 insertions(+), 4 deletions(-)

diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index 79ca1102faed..2eaa21c85483 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c
@@ -2161,7 +2161,7 @@ spi_nor_set_pp_settings(struct spi_nor_pp_command *pp,
  * @nor:       pointer to a 'struct spi_nor'
  * @addr:      offset in the serial flash memory
  * @len:       number of bytes to read
- * @buf:       buffer where the data is copied into
+ * @buf:       buffer where the data is copied into (dma-safe memory)
  *
  * Return: 0 on success, -errno otherwise.
  */
@@ -2868,11 +2868,16 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor 
*nor, const u32 *smpt,
                                         u8 smpt_len)
 {
        const u32 *ret;
+       u8 *dma_safe;
        u32 addr;
        int err;
        u8 i, ncmds, nmaps;
        u8 addr_width, read_opcode, read_dummy;
-       u8 read_data_mask, data_byte, map_id;
+       u8 read_data_mask, map_id;
+
+       dma_safe = kmalloc(sizeof(*dma_safe), GFP_KERNEL | GFP_DMA);
+       if (!dma_safe)
+               return ERR_PTR(-ENOMEM);
 
        addr_width = nor->addr_width;
        read_dummy = nor->read_dummy;
@@ -2890,7 +2895,7 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor 
*nor, const u32 *smpt,
                nor->read_opcode = SMPT_CMD_OPCODE(smpt[i]);
                addr = smpt[i + 1];
 
-               err = spi_nor_read_raw(nor, addr, 1, &data_byte);
+               err = spi_nor_read_raw(nor, addr, 1, dma_safe);
                if (err) {
                        ret = ERR_PTR(err);
                        goto out;
@@ -2900,7 +2905,7 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor 
*nor, const u32 *smpt,
                 * Build an index value that is used to select the Sector Map
                 * Configuration that is currently in use.
                 */
-               map_id = map_id << 1 | !!(data_byte & read_data_mask);
+               map_id = map_id << 1 | !!(*dma_safe & read_data_mask);
                ncmds++;
        }
 
@@ -2941,6 +2946,7 @@ static const u32 *spi_nor_get_map_in_use(struct spi_nor 
*nor, const u32 *smpt,
 
        /* fall through */
 out:
+       kfree(dma_safe);
        nor->addr_width = addr_width;
        nor->read_dummy = read_dummy;
        nor->read_opcode = read_opcode;
-- 
2.9.4

Reply via email to