On Tue, Nov 20, 2018 at 08:08:36AM +0000, [email protected] wrote:
> This patch describes the compatible and the device tree
> bindings necessary for the SAMA5D2 PIOBU GPIO.
>
> Signed-off-by: Andrei Stefanescu <[email protected]>
> ---
> .../bindings/gpio/gpio-sama5d2-piobu.txt | 31
> ++++++++++++++++++++++
> 1 file changed, 31 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt
>
> diff --git a/Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt
> b/Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt
> new file mode 100644
> index 0000000..2e260e1
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/gpio-sama5d2-piobu.txt
microchip,sama5d2-piobu.txt for the file name.
> @@ -0,0 +1,31 @@
> +GPIO controller for SAMA5D2 PIOBU pins.
> +
> +These pins have the property of not losing their voltage
> +during Backup/Self-refresh mode.
> +
> +These bindings should be set to a node in the dtsi file.
> +
> +Required properties:
> +- compatible: "syscon", "microchip,sama5d2-piobu"
syscon should be removed.
> +- #gpio-cells: There are 2. The pin number is the
> + first, the second represents additional
> + parameters such as GPIO_ACTIVE_HIGH/LOW.
> +- gpio-controller: Marks the port as GPIO controller.
> +
> +Note that the driver uses syscon and should be the child of
> +the syscon node.
child of the "atmel,sama5d2-secumod" node to be more specific.
But why do you need a child node? The parent can be a gpio provider.
What other nodes does this need?
> +
> +Example:
> +
> + secumod@fc040000 {
> + compatible = "atmel,sama5d2-secumod", "syscon", "simple-mfd";
This is not documented as being a simple-mfd.
> + status = "okay";
> + reg = <0xfc040000 0x100>;
> +
> + pioBU: piobu {
gpio {
Is there not a register range you can put here?
> + status = "okay";
> + compatible = "microchip,sama5d2-piobu";
> + gpio-controller;
> + #gpio-cells = <2>;
> + };
> + };
> --
> 2.7.4
>
