On Mon, 10 Dec 2018 17:15:29 +0000 <[email protected]> wrote:
> From: Cyrille Pitchen <[email protected]> > > This patch configures the QSPI0 controller pin muxing and declares > a jedec,spi-nor memory. > > sama5d2 Xplained RevB and RevC use the Macronix MX25L25673G flash > memory which advertises a maximum frequency of 80MHz for Quad IO > Fast Read. Set the spi-max-frequency to 80MHz knowing that actually > the QSPI drver will set the SPI bus clock to 166MHz / 3 = 55.3MHz. > > Signed-off-by: Cyrille Pitchen <[email protected]> > [[email protected]: > - drop partitions, > - add spi-rx/tx-bus-width > - change spi-max-frequency to match the 80MHz limit advertised by > MX25L25673G for Quad IO Fast Read, > - reword commit message and subject.] > Signed-off-by: Tudor Ambarus <[email protected]> > --- > arch/arm/boot/dts/at91-sama5d2_xplained.dts | 31 > +++++++++++++++++++++++++++++ > 1 file changed, 31 insertions(+) > > diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts > b/arch/arm/boot/dts/at91-sama5d2_xplained.dts > index 518e2b095ccf..171bc82cfbbf 100644 > --- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts > +++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts > @@ -108,6 +108,21 @@ > }; > > apb { > + qspi0: spi@f0020000 { > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_qspi0_default>; > + /* status = "okay"; */ /* conflict with sdmmc1 > */ > + > + flash@0 { > + compatible = "jedec,spi-nor"; > + reg = <0>; > + spi-max-frequency = <80000000>; > + spi-tx-bus-width = <4>; > + spi-rx-bus-width = <4>; > + m25p,fast-read; > + }; I'm a bit lost. What's the point of defining this if the QSPI controller is not enabled?
