From: Rajendra Nayak <[email protected]> geni spi needs to express a perforamnce state requirement on CX depending on the frequency of the clock rates. Use OPP table from DT to register with OPP framework and use dev_pm_opp_set_rate() to set the clk/perf state.
Signed-off-by: Rajendra Nayak <[email protected]> Signed-off-by: Stephen Boyd <[email protected]> --- drivers/spi/spi-geni-qcom.c | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-) diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c index fdb7cb88fb56..3ffb6b25b58d 100644 --- a/drivers/spi/spi-geni-qcom.c +++ b/drivers/spi/spi-geni-qcom.c @@ -116,9 +116,9 @@ static int get_spi_clk_cfg(unsigned int speed_hz, dev_dbg(mas->dev, "req %u=>%u sclk %lu, idx %d, div %d\n", speed_hz, actual_hz, sclk_freq, *clk_idx, *clk_div); - ret = clk_set_rate(se->clk, sclk_freq); + ret = dev_pm_opp_set_rate(mas->dev, sclk_freq); if (ret) - dev_err(mas->dev, "clk_set_rate failed %d\n", ret); + dev_err(mas->dev, "dev_pm_opp_set_rate failed %d\n", ret); return ret; } @@ -564,6 +564,12 @@ static int spi_geni_probe(struct platform_device *pdev) if (!spi) return -ENOMEM; + ret = dev_pm_opp_of_add_table(&pdev->dev); + if (ret < 0) { + dev_err(&pdev->dev, "failed to init OPP table: %d\n", ret); + return ret; + } + platform_set_drvdata(pdev, spi); mas = spi_master_get_devdata(spi); mas->irq = irq; @@ -629,6 +635,8 @@ static int __maybe_unused spi_geni_runtime_suspend(struct device *dev) struct spi_master *spi = dev_get_drvdata(dev); struct spi_geni_master *mas = spi_master_get_devdata(spi); + /* Drop the performance state vote */ + dev_pm_opp_set_rate(dev, 0); return geni_se_resources_off(&mas->se); } -- Sent by a computer through tubes
