According to NXP's FAE feedback and a comment in ATF firmware, PCIE1 and PCIE2 power domains can't really be used independently. Due to shared reset line both power domains have to be turned on at the same time. Account for that quirk by combining PCIE power domains into a single 'pgc_pcie' power domain.
Signed-off-by: Andrey Smirnov <[email protected]> Cc: Shawn Guo <[email protected]> Cc: Fabio Estevam <[email protected]> Cc: Chris Healy <[email protected]> Cc: Lucas Stach <[email protected]> Cc: Leonard Crestez <[email protected]> Cc: "A.s. Dong" <[email protected]> Cc: Richard Zhu <[email protected]> Cc: [email protected] Cc: [email protected] Cc: [email protected] --- arch/arm64/boot/dts/freescale/imx8mq.dtsi | 21 ++++++++++++++++++++- 1 file changed, 20 insertions(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi b/arch/arm64/boot/dts/freescale/imx8mq.dtsi index 50436bd393ed..89babc531380 100644 --- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi +++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi @@ -273,9 +273,28 @@ reg = <IMX8M_POWER_DOMAIN_MIPI>; }; - pgc_pcie1: power-domain@1 { + /* + * As per comment in ATF source code: + * + * PCIE1 and PCIE2 share the + * same reset signal, if we + * power down PCIE2, PCIE1 + * will be held in reset too. + * + * So instead of creating two + * separate power domains for + * PCIE1 and PCIE2. We create + * a link between 1 and 10 and + * use what was supposed to be + * domain 1 as a shared PCIE + * power domain powering both + * PCIE1 and PCIE2 at the same + * time + */ + pgc_pcie: power-domain@1 { #power-domain-cells = <0>; reg = <IMX8M_POWER_DOMAIN_PCIE1>; + power-domains = <&pgc_pcie2>; }; pgc_otg1: power-domain@2 { -- 2.20.1
