On Thu, Feb 28, 2019 at 2:39 PM Paul Walmsley <[email protected]> wrote: > > Hello Alistair, > > On Thu, 28 Feb 2019, Alistair Francis wrote: > > > This reverts commit 6778be4e520959659b27a441c06a84c9cb009085. > > > > Reverting the commit fixes these error messages and an non-functioning > > USB bus when attaching a USB to PCIe card to a RISC-V board: > > xhci_hcd 0000:03:00.0: Host took too long to start, waited 16000 > > microseconds. > > xhci_hcd 0000:03:00.0: startup error -19 > > xhci_hcd 0000:03:00.0: USB bus 2 deregistered > > xhci_hcd 0000:03:00.0: WARNING: Host System Error > > xhci_hcd 0000:03:00.0: remove, state 1 > > > > Signed-off-by: Alistair Francis <[email protected]> > > --- > > I'm not sure if this is the correct fix, it's possible something else is > > wrong, but I wanted to get some feedback. > > > > drivers/of/device.c | 4 +--- > > 1 file changed, 1 insertion(+), 3 deletions(-) > > > > diff --git a/drivers/of/device.c b/drivers/of/device.c > > index 3717f2a20d0d..8299f8055da7 100644 > > --- a/drivers/of/device.c > > +++ b/drivers/of/device.c > > @@ -149,11 +149,9 @@ int of_dma_configure(struct device *dev, struct > > device_node *np, bool force_dma) > > * set by the driver. > > */ > > mask = DMA_BIT_MASK(ilog2(dma_addr + size - 1) + 1); > > + dev->bus_dma_mask = mask; > > dev->coherent_dma_mask &= mask; > > *dev->dma_mask &= mask; > > - /* ...but only set bus mask if we found valid dma-ranges earlier */ > > Does the DT data for the PCIe controller that you're using contain a > dma-ranges node?
Ah, no it does not. It only has ranges and bus-range [1]. Any idea what the dma-ranges should be? 1: https://github.com/riscv/opensbi/blob/master/platform/sifive/fu540/HiFiveUnleashed-MicroSemi-Expansion.dts#L407 Alistair > > > - if (!ret) > > - dev->bus_dma_mask = mask; > > > > coherent = of_dma_is_coherent(np); > > dev_dbg(dev, "device is%sdma coherent\n", > > > - Paul
