Add an ABI documentation for the ad5933 driver.

Signed-off-by: Marcelo Schmitt <[email protected]>
---
 .../ABI/testing/sysfs-bus-iio-ad5933          | 39 +++++++++++++++++++
 1 file changed, 39 insertions(+)
 create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-ad5933

diff --git a/Documentation/ABI/testing/sysfs-bus-iio-ad5933 
b/Documentation/ABI/testing/sysfs-bus-iio-ad5933
new file mode 100644
index 000000000000..8a60dd178b1f
--- /dev/null
+++ b/Documentation/ABI/testing/sysfs-bus-iio-ad5933
@@ -0,0 +1,39 @@
+What:/sys/bus/iio/devices/iio:deviceX/out_voltage0_freq_start
+Date:          March 2019
+KernelVersion: Kernel 4.19
+Contact:       [email protected]
+Description:
+               The start frequency. Set this to define the frequency point at
+               which the device should start the next frequency sweep.
+
+What:/sys/bus/iio/devices/iio:deviceX/out_voltage0_freq_increment
+Date:          March 2019
+KernelVersion: Kernel 4.19
+Contact:       [email protected]
+Description:
+               The frequency sweep increment. Set this to define the amount by
+               which the frequency is incremented after each scan point. After
+               the measurement at a frequency point is completed, the next
+               measurement will be made at a frequency point 
+               'frequency increment'Hz higher than the previous one unless a
+               repeat frequency command is issued. This behavior will follow
+               until the defined number of frequency points have been measured
+               or frequency sweep is somewhat reset.
+
+What:/sys/bus/iio/devices/iio:deviceX/out_voltage0_freq_points
+Date:          March 2019
+KernelVersion: Kernel 4.19
+Contact:       [email protected]
+Description:
+               The number of increments. This defines the number of frequency
+               points in the frequency sweep.
+
+What:/sys/bus/iio/devices/iio:deviceX/out_voltage0_settling_cycles
+Date:          March 2019
+KernelVersion: Kernel 4.19
+Contact:       [email protected]
+Description:
+               Number of settling time cycles. This sets the delay between a
+               start frequency sweep/increment frequency /repeat frequency to
+               be proportional to the excitation signal frequency times the
+               number of settling time cycles.
-- 
2.20.1

Reply via email to