Formatting of Kconfig files doesn't look so pretty, so let the Great White Handkerchief come around and clean it up.
Signed-off-by: Enrico Weigelt, metux IT consult <[email protected]> --- drivers/mcb/Kconfig | 47 ++++++++++++++++++++++------------------------- 1 file changed, 22 insertions(+), 25 deletions(-) diff --git a/drivers/mcb/Kconfig b/drivers/mcb/Kconfig index 76d9c51..85b4f22 100644 --- a/drivers/mcb/Kconfig +++ b/drivers/mcb/Kconfig @@ -3,38 +3,35 @@ # menuconfig MCB - tristate "MCB support" - default n - depends on HAS_IOMEM - help + tristate "MCB support" + default n + depends on HAS_IOMEM + help + The MCB (MEN Chameleon Bus) is a Bus specific to MEN Mikroelektronik + FPGA based devices. It is used to identify MCB based IP-Cores within + an FPGA and provide the necessary framework for instantiating drivers + for these devices. - The MCB (MEN Chameleon Bus) is a Bus specific to MEN Mikroelektronik - FPGA based devices. It is used to identify MCB based IP-Cores within - an FPGA and provide the necessary framework for instantiating drivers - for these devices. - - If build as a module, the module is called mcb.ko + If build as a module, the module is called mcb.ko if MCB config MCB_PCI - tristate "PCI based MCB carrier" - default n - depends on PCI - help - - This is a MCB carrier on a PCI device. Both PCI attached on-board - FPGAs as well as CompactPCI attached MCB FPGAs are supported with - this driver. + tristate "PCI based MCB carrier" + default n + depends on PCI + help + This is a MCB carrier on a PCI device. Both PCI attached on-board + FPGAs as well as CompactPCI attached MCB FPGAs are supported with + this driver. - If build as a module, the module is called mcb-pci.ko + If build as a module, the module is called mcb-pci.ko config MCB_LPC - tristate "LPC (non PCI) based MCB carrier" - default n - help - - This is a MCB carrier on a LPC or non PCI device. + tristate "LPC (non PCI) based MCB carrier" + default n + help + This is a MCB carrier on a LPC or non PCI device. - If build as a module, the module is called mcb-lpc.ko + If build as a module, the module is called mcb-lpc.ko endif # MCB -- 1.9.1
