Hi, Sorry for late reply.
On 19. 2. 26. 오전 1:58, Paweł Chmiel wrote: > From: Tomasz Figa <[email protected]> > > This patch adds documentation for binding of extcont Fairchild > Semiconductor FSA9480 microusb switch. > This usb port accessory detector and switch, can be found for example in > some Samsung s5pv210 based phones. > > Signed-off-by: Tomasz Figa <[email protected]> > Signed-off-by: Paweł Chmiel <[email protected]> > --- > .../bindings/extcon/extcon-fsa9480.txt | 21 +++++++++++++++++++ > 1 file changed, 21 insertions(+) > create mode 100644 > Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > > diff --git a/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > b/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > new file mode 100644 > index 000000000000..ebced7b18eb5 > --- /dev/null > +++ b/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > @@ -0,0 +1,21 @@ > +FAIRCHILD SEMICONDUCTOR FSA9480 MICROUSB SWITCH > + > +The FSA9480 is a USB port accessory detector and switch. The FSA9480 is fully > +controlled using I2C and enables USB data, stereo and mono audio, video, > +microphone, and UART data to use a common connector port. > + > +Required properties: > + - compatible : Must be "fcs,fsa9480" > + - reg : Specifies i2c slave address. Must be 0x25. > + - interrupt-parent : Phandle to interrupt controller to which interrupt > + signal of the chip is connected. > + - interrupts : Should contain one entry specifying interrupt signal of > + interrupt parent to which interrupt pin of the chip is connected. > + > + Example: > + musb@25 { > + compatible = "fcs,fsa9480"; > + reg = <0x25>; > + interrupt-parent = <&gph2>; > + interrupts = <7 0>; > + }; > \ No newline at end of file > Acked-by: Chanwoo Choi <[email protected]> -- Best Regards, Chanwoo Choi Samsung Electronics
