Use the runtime-detected denali->nbanks instead of hard-coded
DENALI_NR_BANKS (=4).
The actual number of banks depends on the IP configuration, and
can be less than DENALI_NR_BANKS. It is pointless to touch
registers of unsupported banks.
Signed-off-by: Masahiro Yamada <yamada.masah...@socionext.com>
---
Changes in v5: None
Changes in v4: None
Changes in v3: None
Changes in v2: None
drivers/mtd/nand/raw/denali.c | 9 ++++-----
1 file changed, 4 insertions(+), 5 deletions(-)
diff --git a/drivers/mtd/nand/raw/denali.c b/drivers/mtd/nand/raw/denali.c
index 8722762..e918c3d 100644
--- a/drivers/mtd/nand/raw/denali.c
+++ b/drivers/mtd/nand/raw/denali.c
@@ -40,7 +40,6 @@
#define DENALI_BANK(denali) ((denali)->active_bank << 24)
#define DENALI_INVALID_BANK -1
-#define DENALI_NR_BANKS 4
static struct denali_chip *to_denali_chip(struct nand_chip *chip)
{
@@ -92,7 +91,7 @@ static void denali_enable_irq(struct denali_controller
*denali)
{
int i;
- for (i = 0; i < DENALI_NR_BANKS; i++)
+ for (i = 0; i < denali->nbanks; i++)
iowrite32(U32_MAX, denali->reg + INTR_EN(i));
iowrite32(GLOBAL_INT_EN_FLAG, denali->reg + GLOBAL_INT_ENABLE);
}
@@ -101,7 +100,7 @@ static void denali_disable_irq(struct denali_controller
*denali)
{
int i;
- for (i = 0; i < DENALI_NR_BANKS; i++)
+ for (i = 0; i < denali->nbanks; i++)
iowrite32(0, denali->reg + INTR_EN(i));
iowrite32(0, denali->reg + GLOBAL_INT_ENABLE);
}
@@ -117,7 +116,7 @@ static void denali_clear_irq_all(struct denali_controller
*denali)
{
int i;
- for (i = 0; i < DENALI_NR_BANKS; i++)
+ for (i = 0; i < denali->nbanks; i++)
denali_clear_irq(denali, i, U32_MAX);
}
@@ -130,7 +129,7 @@ static irqreturn_t denali_isr(int irq, void *dev_id)
spin_lock(&denali->irq_lock);
- for (i = 0; i < DENALI_NR_BANKS; i++) {
+ for (i = 0; i < denali->nbanks; i++) {
irq_status = ioread32(denali->reg + INTR_STATUS(i));
if (irq_status)
ret = IRQ_HANDLED;
--
2.7.4
