On Mon, Jun 10, 2019 at 7:11 PM Grygorii Strashko <grygorii.stras...@ti.com> wrote:
> From: Russell King <rmk+ker...@armlinux.org.uk> > > Documentation states: > > NOTE: There must be a correlation between the wake-up enable and > interrupt-enable registers. If a GPIO pin has a wake-up configured > on it, it must also have the corresponding interrupt enabled (on > one of the two interrupt lines). > > Ensure that this condition is always satisfied by enabling the detection > events after enabling the interrupt, and disabling the detection before > disabling the interrupt. This ensures interrupt/wakeup events can not > happen until both the wakeup and interrupt enables correlate. > > If we do any clearing, clear between the interrupt enable/disable and > trigger setting. > > Signed-off-by: Russell King <rmk+ker...@armlinux.org.uk> > Signed-off-by: Grygorii Strashko <grygorii.stras...@ti.com> Patch applied. Yours, Linus Walleij
