On Wed, 2019-06-26 at 15:39 +0200, Wolfram Sang wrote: > Hi, > > On Tue, Jun 11, 2019 at 04:11:54PM +0800, Qii Wang wrote: > > Add i2c AC timing binding to binding file. It can give the AC > > timing parameters to meet I2C specification at different speed. > > > > Signed-off-by: Qii Wang <qii.w...@mediatek.com> > > I think this is a too specific 1:1 mapping of your register set into DT > world. We already have these generic parameters: > > - clock-frequency > frequency of bus clock in Hz. > > - i2c-scl-falling-time-ns > Number of nanoseconds the SCL signal takes to fall; t(f) in the I2C > specification. > > - i2c-scl-internal-delay-ns > Number of nanoseconds the IP core additionally needs to setup SCL. > > - i2c-scl-rising-time-ns > Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C > specification. > > - i2c-sda-falling-time-ns > Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C > specification. > > (check Documentation/devicetree/bindings/i2c/i2c.txt) > > Can't you use those to derive your values from that? Which ones are you > missing > if not? > > Regards, > > Wolfram
I have take a little time to develop a new patch which based on your suggestions, and it tested OK. Thanks for your suggestions, I will update the patch after I test it fully.
