From: Ondřej Jirman <m...@xff.cz> Date: Jul/22/2019, 13:42:40 (UTC+00:00)
> Hello Jose,
>
> On Tue, Jun 11, 2019 at 05:18:44PM +0200, Jose Abreu wrote:
> > [ Hope this diff looks better (generated with --minimal) ]
> >
> > This converts stmmac to use phylink. Besides the code redution this will
> > allow to gain more flexibility.
>
> I'm testing 5.3-rc1 and on Orange Pi 3 (uses stmmac-sun8i.c glue) compared to
> 5.2 it fails to detect 1000Mbps link and the driver negotiates just a 10Mbps
> speed.
>
> After going through stmmac patches since 5.2, I think it may be realted to
> this
> series, but I'm not completely sure. You'll probably have a better
> understanding
> of the changes. Do you have an idea what might be wrong? Please, see some logs
> below.
Probably due to:
5b0d7d7da64b ("net: stmmac: Add the missing speeds that XGMAC supports")
Can you try attached patch ?
>
> thank you and regards,
> Ondrej
>
> On 5.3-rc1 I see:
>
> [ 6.116512] dwmac-sun8i 5020000.ethernet eth0: PHY [stmmac-0:01] driver
> [RTL8211E Gigabit Ethernet]
> [ 6.116522] dwmac-sun8i 5020000.ethernet eth0: phy: setting supported
> 00,00000000,000062cf advertising 00,00000000,000062cf
> [ 6.118714] dwmac-sun8i 5020000.ethernet eth0: No Safety Features support
> found
> [ 6.118725] dwmac-sun8i 5020000.ethernet eth0: No MAC Management Counters
> available
> [ 6.118730] dwmac-sun8i 5020000.ethernet eth0: PTP not supported by HW
> [ 6.118738] dwmac-sun8i 5020000.ethernet eth0: configuring for phy/rgmii
> link mode
> [ 6.118747] dwmac-sun8i 5020000.ethernet eth0: phylink_mac_config:
> mode=phy/rgmii/Unknown/Unknown adv=00,00000000,000062cf pause=10 link=0 an=1
> [ 6.126099] dwmac-sun8i 5020000.ethernet eth0: phy link down
> rgmii/Unknown/Unknown
> [ 6.276325] random: crng init done
> [ 6.276338] random: 7 urandom warning(s) missed due to ratelimiting
> [ 7.543987] zram0: detected capacity change from 0 to 402653184
> [ 7.667702] Adding 393212k swap on /dev/zram0. Priority:10 extents:1
> across:393212k SS
>
> ... delay due to other causes ...
>
> [ 28.640234] dwmac-sun8i 5020000.ethernet eth0: phy link up
> rgmii/10Mbps/Full
> [ 28.640295] dwmac-sun8i 5020000.ethernet eth0: phylink_mac_config:
> mode=phy/rgmii/10Mbps/Full adv=00,00000000,00000000 pause=0f link=1 an=0
> [ 28.640324] dwmac-sun8i 5020000.ethernet eth0: Link is Up - 10Mbps/Full -
> flow control rx/tx
>
> Settings for eth0:
> Supported ports: [ TP MII ]
> Supported link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> Supported pause frame use: Symmetric Receive-only
> Supports auto-negotiation: Yes
> Supported FEC modes: Not reported
> Advertised link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> Advertised pause frame use: Symmetric Receive-only
> Advertised auto-negotiation: Yes
> Advertised FEC modes: Not reported
> Link partner advertised link modes: 10baseT/Half 10baseT/Full
> Link partner advertised pause frame use: Symmetric Receive-only
> Link partner advertised auto-negotiation: Yes
> Link partner advertised FEC modes: Not reported
> Speed: 10Mb/s
> Duplex: Full
> Port: MII
> PHYAD: 1
> Transceiver: internal
> Auto-negotiation: on
> Supports Wake-on: d
> Wake-on: d
> Current message level: 0x0000003f (63)
> drv probe link timer ifdown ifup
> Link detected: yes
>
> On 5.2 it looks like this:
>
> [ 1.153596] dwmac-sun8i 5020000.ethernet: PTP uses main clock
> [ 1.416221] dwmac-sun8i 5020000.ethernet: PTP uses main clock
> [ 1.522735] dwmac-sun8i 5020000.ethernet: Current syscon value is not the
> default 58000 (expect 50000)
> [ 1.522750] dwmac-sun8i 5020000.ethernet: No HW DMA feature register
> supported
> [ 1.522753] dwmac-sun8i 5020000.ethernet: RX Checksum Offload Engine
> supported
> [ 1.522755] dwmac-sun8i 5020000.ethernet: COE Type 2
> [ 1.522758] dwmac-sun8i 5020000.ethernet: TX Checksum insertion supported
> [ 1.522761] dwmac-sun8i 5020000.ethernet: Normal descriptors
> [ 1.522763] dwmac-sun8i 5020000.ethernet: Chain mode enabled
> [ 5.352833] dwmac-sun8i 5020000.ethernet eth0: No Safety Features support
> found
> [ 5.352842] dwmac-sun8i 5020000.ethernet eth0: No MAC Management Counters
> available
> [ 5.352846] dwmac-sun8i 5020000.ethernet eth0: PTP not supported by HW
> [ 10.463072] dwmac-sun8i 5020000.ethernet eth0: Link is Up - 1Gbps/Full -
> flow control off
>
> Settings for eth0:
> Supported ports: [ TP MII ]
> Supported link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> 1000baseT/Half 1000baseT/Full
> Supported pause frame use: Symmetric Receive-only
> Supports auto-negotiation: Yes
> Supported FEC modes: Not reported
> Advertised link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> 1000baseT/Half 1000baseT/Full
> Advertised pause frame use: No
> Advertised auto-negotiation: Yes
> Advertised FEC modes: Not reported
> Link partner advertised link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> 1000baseT/Full
> Link partner advertised pause frame use: Symmetric Receive-only
> Link partner advertised auto-negotiation: Yes
> Link partner advertised FEC modes: Not reported
> Speed: 1000Mb/s
> Duplex: Full
> Port: MII
> PHYAD: 1
> Transceiver: internal
> Auto-negotiation: on
> Supports Wake-on: d
> Wake-on: d
> Current message level: 0x0000003f (63)
> drv probe link timer ifdown ifup
> Link detected: yes
>
>
> > Cc: Joao Pinto <jpi...@synopsys.com>
> > Cc: David S. Miller <da...@davemloft.net>
> > Cc: Giuseppe Cavallaro <peppe.cavall...@st.com>
> > Cc: Alexandre Torgue <alexandre.tor...@st.com>
> > Cc: Russell King <li...@armlinux.org.uk>
> > Cc: Andrew Lunn <and...@lunn.ch>
> > Cc: Florian Fainelli <f.faine...@gmail.com>
> > Cc: Heiner Kallweit <hkallwe...@gmail.com>
> >
> > Jose Abreu (3):
> > net: stmmac: Prepare to convert to phylink
> > net: stmmac: Start adding phylink support
> > net: stmmac: Convert to phylink and remove phylib logic
> >
> > drivers/net/ethernet/stmicro/stmmac/Kconfig | 3 +-
> > drivers/net/ethernet/stmicro/stmmac/stmmac.h | 7 +-
> > .../ethernet/stmicro/stmmac/stmmac_ethtool.c | 81 +---
> > .../net/ethernet/stmicro/stmmac/stmmac_main.c | 391 ++++++++----------
> > .../ethernet/stmicro/stmmac/stmmac_platform.c | 21 +-
> > 5 files changed, 190 insertions(+), 313 deletions(-)
> >
> > --
> > 2.21.0
> >
---
Thanks,
Jose Miguel Abreu
0001-net-stmmac-Do-not-cut-down-1G-modes.patch
Description: 0001-net-stmmac-Do-not-cut-down-1G-modes.patch
