Some glue logic drivers support 1G without having GMAC/GMAC4/XGMAC. Let's allow this speed by default.
Reported-by: Ondrej Jirman <[email protected]> Tested-by: Ondrej Jirman <[email protected]> Fixes: 5b0d7d7da64b ("net: stmmac: Add the missing speeds that XGMAC supports") Signed-off-by: Jose Abreu <[email protected]> --- Cc: Giuseppe Cavallaro <[email protected]> Cc: Alexandre Torgue <[email protected]> Cc: Jose Abreu <[email protected]> Cc: "David S. Miller" <[email protected]> Cc: Maxime Coquelin <[email protected]> Cc: [email protected] Cc: [email protected] Cc: [email protected] Cc: [email protected] Cc: Ondrej Jirman <[email protected]> --- drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 11 +++-------- 1 file changed, 3 insertions(+), 8 deletions(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index 207c3755bcc5..b0d5e5346597 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -814,20 +814,15 @@ static void stmmac_validate(struct phylink_config *config, phylink_set(mac_supported, 10baseT_Full); phylink_set(mac_supported, 100baseT_Half); phylink_set(mac_supported, 100baseT_Full); + phylink_set(mac_supported, 1000baseT_Half); + phylink_set(mac_supported, 1000baseT_Full); + phylink_set(mac_supported, 1000baseKX_Full); phylink_set(mac_supported, Autoneg); phylink_set(mac_supported, Pause); phylink_set(mac_supported, Asym_Pause); phylink_set_port_modes(mac_supported); - if (priv->plat->has_gmac || - priv->plat->has_gmac4 || - priv->plat->has_xgmac) { - phylink_set(mac_supported, 1000baseT_Half); - phylink_set(mac_supported, 1000baseT_Full); - phylink_set(mac_supported, 1000baseKX_Full); - } - /* Cut down 1G if asked to */ if ((max_speed > 0) && (max_speed < 1000)) { phylink_set(mask, 1000baseT_Full); -- 2.7.4
