On Sat 05 Oct 04:46 PDT 2019, Brian Masney wrote:
> diff --git a/drivers/interconnect/qcom/msm8974.c
> b/drivers/interconnect/qcom/msm8974.c
[..]
> +static void msm8974_icc_rpm_smd_send(struct device *dev, int rsc_type,
> + char *name, int id, u64 val)
> +{
> + int ret;
> +
> + if (id == -1)
> + return;
> +
> + /*
> + * Setting the bandwidth requests for some nodes fails and this same
> + * behavior occurs on the downstream MSM 3.4 kernel sources based on
> + * errors like this in that kernel:
> + *
> + * msm_rpm_get_error_from_ack(): RPM NACK Unsupported resource
> + * AXI: msm_bus_rpm_req(): RPM: Ack failed
> + * AXI: msm_bus_rpm_commit_arb(): RPM: Req fail: mas:32, bw:240000000
> + *
> + * Since there's no publicly available documentation for this hardware,
> + * and the bandwidth for some nodes in the path can be set properly,
> + * let's not return an error.
> + */
So presumably all that matters for paths including these endpoints is
the clk_set_rate() on the bus itself. But I prefer that we merge it like
you propose and then swing back to work out the details.
> + ret = qcom_icc_rpm_smd_send(QCOM_SMD_RPM_ACTIVE_STATE, rsc_type, id,
> + val);
> + if (ret)
> + dev_dbg(dev, "Cannot set bandwidth for node %s (%d): %d\n",
> + name, id, ret);
> +}
> +
Reviewed-by: Bjorn Andersson <[email protected]>
Regards,
Bjorn
