On 18. 10. 19 8:54, Radhey Shyam Pandey wrote: > xilinx axi_emac driver is supported on ZynqMP UltraScale platform(ARM64). > So enable it in kconfig. Basic sanity testing is done on zu+ mpsoc zcu102 > evaluation board. > > Signed-off-by: Radhey Shyam Pandey <[email protected]> > --- > drivers/net/ethernet/xilinx/Kconfig | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) > > diff --git a/drivers/net/ethernet/xilinx/Kconfig > b/drivers/net/ethernet/xilinx/Kconfig > index 8d994ce..a616bdc 100644 > --- a/drivers/net/ethernet/xilinx/Kconfig > +++ b/drivers/net/ethernet/xilinx/Kconfig > @@ -6,7 +6,7 @@ > config NET_VENDOR_XILINX > bool "Xilinx devices" > default y > - depends on PPC || PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS || X86 || > ARM || COMPILE_TEST > + depends on PPC || PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS || X86 || > ARM || ARM64 || COMPILE_TEST
You can remove ARCH_ZYNQ from this line because ARM is there already. > ---help--- > If you have a network (Ethernet) card belonging to this class, say Y. > > @@ -26,11 +26,11 @@ config XILINX_EMACLITE > > config XILINX_AXI_EMAC > tristate "Xilinx 10/100/1000 AXI Ethernet support" > - depends on MICROBLAZE || X86 || ARM || COMPILE_TEST > + depends on MICROBLAZE || X86 || ARM || ARM64 || COMPILE_TEST > select PHYLINK > ---help--- > This driver supports the 10/100/1000 Ethernet from Xilinx for the > - AXI bus interface used in Xilinx Virtex FPGAs. > + AXI bus interface used in Xilinx Virtex FPGAs and Soc's. > > config XILINX_LL_TEMAC > tristate "Xilinx LL TEMAC (LocalLink Tri-mode Ethernet MAC) driver" > M
