On 6/12/2020 10:13 AM, Nicolas Saenz Julienne wrote: > Some atypical users of xhci-pci might need to manually reset their xHCI > controller before starting the HCD setup. Check if a reset controller > device is available to the PCI bus and trigger a reset. > > Signed-off-by: Nicolas Saenz Julienne <[email protected]> Reviewed-by: Florian Fainelli <[email protected]> -- Florian
- [PATCH v3 0/9] Raspberry Pi 4 USB firmware initiali... Nicolas Saenz Julienne
- [PATCH v3 7/9] usb: host: pci-quirks: Bypass x... Nicolas Saenz Julienne
- [PATCH v3 3/9] ARM: dts: bcm2711: Add firmware... Nicolas Saenz Julienne
- [PATCH v3 9/9] Revert "PCI: brcmstb: Wait... Nicolas Saenz Julienne
- [PATCH v3 4/9] ARM: dts: bcm2711: Add reset co... Nicolas Saenz Julienne
- [PATCH v3 8/9] Revert "firmware: raspberr... Nicolas Saenz Julienne
- [PATCH v3 6/9] Revert "USB: pci-quirks: A... Nicolas Saenz Julienne
- [PATCH v3 2/9] reset: Add Raspberry Pi 4 firmw... Nicolas Saenz Julienne
- [PATCH v3 5/9] usb: xhci-pci: Add support for ... Nicolas Saenz Julienne
- Re: [PATCH v3 5/9] usb: xhci-pci: Add supp... Florian Fainelli
- Re: [PATCH v3 5/9] usb: xhci-pci: Add supp... Mathias Nyman
- [PATCH v3 1/9] dt-bindings: reset: Add a bindi... Nicolas Saenz Julienne
