[PATCH 2/3] ARM: dts: at91: sam9x60ek: classd: pull-down the L1 and L3 lines

[Codrin Ciubotariu]

The L1 and L3 lines drive NMOS transistors that are OFF with a low level.
On the SAM9X60 EK board, if the pins corresponding to L1 and L3
have pull-ups enabled, there is an extra 2 x 30uA power consumption.
Use pull-downs for these 2 lines to remove the unnecessary power
consumption.

Fixes: 1e5f532c2737 ("ARM: dts: at91: sam9x60: add device tree for soc and 
board")
Signed-off-by: Codrin Ciubotariu <codrin.ciubota...@microchip.com>
---
 arch/arm/boot/dts/at91-sam9x60ek.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/at91-sam9x60ek.dts 
b/arch/arm/boot/dts/at91-sam9x60ek.dts
index b484745bf2d4..3b9bb29d9e23 100644
--- a/arch/arm/boot/dts/at91-sam9x60ek.dts
+++ b/arch/arm/boot/dts/at91-sam9x60ek.dts
@@ -470,9 +470,9 @@ classd {
                pinctrl_classd_default: classd {
                        atmel,pins =
                                <AT91_PIOA 24 AT91_PERIPH_C AT91_PINCTRL_PULL_UP
-                                AT91_PIOA 25 AT91_PERIPH_C AT91_PINCTRL_PULL_UP
+                                AT91_PIOA 25 AT91_PERIPH_C 
AT91_PINCTRL_PULL_DOWN
                                 AT91_PIOA 26 AT91_PERIPH_C AT91_PINCTRL_PULL_UP
-                                AT91_PIOA 27 AT91_PERIPH_C 
AT91_PINCTRL_PULL_UP>;
+                                AT91_PIOA 27 AT91_PERIPH_C 
AT91_PINCTRL_PULL_DOWN>;
                };
        };
 
-- 
2.25.1