The definition of SPI_FULL_DUPLEX (3) is really SPI_TX_ONLY (1) ORed with SPI_RX_ONLY (2). Let's drop the define and simplify the code here a bit by collapsing the setting of 'm_cmd' into conditions that are the same.
This is a non-functional change, just cleanup to consolidate code. Cc: Douglas Anderson <[email protected]> Signed-off-by: Stephen Boyd <[email protected]> --- drivers/spi/spi-geni-qcom.c | 13 ++++--------- 1 file changed, 4 insertions(+), 9 deletions(-) diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c index 636c3da15db0..670f83793aa4 100644 --- a/drivers/spi/spi-geni-qcom.c +++ b/drivers/spi/spi-geni-qcom.c @@ -51,7 +51,6 @@ /* M_CMD OP codes for SPI */ #define SPI_TX_ONLY 1 #define SPI_RX_ONLY 2 -#define SPI_FULL_DUPLEX 3 #define SPI_TX_RX 7 #define SPI_CS_ASSERT 8 #define SPI_CS_DEASSERT 9 @@ -357,12 +356,6 @@ static void setup_fifo_xfer(struct spi_transfer *xfer, mas->tx_rem_bytes = 0; mas->rx_rem_bytes = 0; - if (xfer->tx_buf && xfer->rx_buf) - m_cmd = SPI_FULL_DUPLEX; - else if (xfer->tx_buf) - m_cmd = SPI_TX_ONLY; - else if (xfer->rx_buf) - m_cmd = SPI_RX_ONLY; spi_tx_cfg &= ~CS_TOGGLE; @@ -373,12 +366,14 @@ static void setup_fifo_xfer(struct spi_transfer *xfer, len &= TRANS_LEN_MSK; mas->cur_xfer = xfer; - if (m_cmd & SPI_TX_ONLY) { + if (xfer->tx_buf) { + m_cmd |= SPI_TX_ONLY; mas->tx_rem_bytes = xfer->len; writel(len, se->base + SE_SPI_TX_TRANS_LEN); } - if (m_cmd & SPI_RX_ONLY) { + if (xfer->rx_buf) { + m_cmd |= SPI_RX_ONLY; writel(len, se->base + SE_SPI_RX_TRANS_LEN); mas->rx_rem_bytes = xfer->len; } -- Sent by a computer, using git, on the internet
