On Thu, 09 Jul 2020 23:51:33 +0200, Ansuel Smith wrote:
> Document the use of regmap phandle for ipq8064 SoCs
>
> Signed-off-by: Ansuel Smith <[email protected]>
> ---
> .../bindings/thermal/qcom-tsens.yaml | 51 ++++++++++++++++---
> 1 file changed, 44 insertions(+), 7 deletions(-)
>
My bot found errors running 'make dt_binding_check' on your patch:
Documentation/devicetree/bindings/thermal/qcom-tsens.example.dts:21.38-31.11:
Warning (unit_address_vs_reg): /example-0/thermal-sensor@900000: node has a
unit name, but no reg or ranges property
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: interrupts: [[0, 178, 4]] is too short
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: '#qcom,sensors' is a required property
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: 'interrupt-names' is a required property
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: compatible: ['qcom,ipq8064-tsens'] is not valid under
any of the given schemas (Possible causes of the failure):
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: compatible: ['qcom,ipq8064-tsens'] is too short
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: compatible:0: 'qcom,ipq8064-tsens' is not one of
['qcom,msm8976-tsens', 'qcom,qcs404-tsens']
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: compatible:0: 'qcom,ipq8064-tsens' is not one of
['qcom,msm8996-tsens', 'qcom,msm8998-tsens', 'qcom,sc7180-tsens',
'qcom,sdm845-tsens']
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml:
thermal-sensor@900000: nvmem-cell-names:1: 'calib_sel' was expected
See https://patchwork.ozlabs.org/patch/1326228
If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure dt-schema is up to date:
pip3 install git+https://github.com/devicetree-org/dt-schema.git@master
--upgrade
Please check and re-submit.
