On Mon, Aug 24, 2020 at 11:36:37AM +0800, Rahul Tanwar wrote:
> Intel Lightning Mountain(LGM) SoC contains a PWM fan controller.
> This PWM controller does not have any other consumer, it is a
> dedicated PWM controller for fan attached to the system. Add
> driver for this PWM fan controller.

...

> +     pc->regmap = devm_regmap_init_mmio(dev, io_base, 
> &lgm_pwm_regmap_config);
> +     if (IS_ERR(pc->regmap)) {
> +             ret = PTR_ERR(pc->regmap);
> +             if (ret != -EPROBE_DEFER)
> +                     dev_err_probe(dev, ret, "failed to init register 
> map\n");
> +             return ret;
> +     }
> +
> +     pc->clk = devm_clk_get(dev, NULL);
> +     if (IS_ERR(pc->clk)) {
> +             ret = PTR_ERR(pc->clk);
> +             if (ret != -EPROBE_DEFER)
> +                     dev_err_probe(dev, ret, "failed to get clock\n");
> +             return ret;
> +     }
> +
> +     pc->rst = devm_reset_control_get_exclusive(dev, NULL);
> +     if (IS_ERR(pc->rst)) {
> +             ret = PTR_ERR(pc->rst);
> +             if (ret != -EPROBE_DEFER)
> +                     dev_err_probe(dev, ret, "failed to get reset 
> control\n");
> +             return ret;
> +     }
> +
> +     ret = reset_control_deassert(pc->rst);
> +     if (ret) {
> +             if (ret != -EPROBE_DEFER)
> +                     dev_err_probe(dev, ret, "cannot deassert reset 
> control\n");
> +             return ret;
> +     }

Please, spend a bit of time to understand the changes you are doing. There are
already few examples how to use dev_err_probe() properly.

> +     ret = clk_prepare_enable(pc->clk);
> +     if (ret) {
> +             dev_err(dev, "failed to enable clock\n");
> +             return ret;
> +     }
> +
> +     ret = devm_add_action_or_reset(dev, lgm_pwm_action, pc);
> +     if (ret)
> +             return ret;

You have also ordering issues here.

So, what I can see about implementation is that


        static void ..._clk_disable(void *data)
        {
                clk_disable_unprepare(data);
        }

        static int ..._clk_enable(...)
        {
                int ret;

                ret = clk_preare_enable(...);
                if (ret)
                        return ret;
                return devm_add_action_or_reset(..., ..._clk_disable);
        }


Similar for reset control.

Then in the ->probe() something like this:

        ret = devm_reset_control_get...;
        if (ret)
                return ret;

        ret = ..._reset_deassert(...);
        if (ret)
                return ret;

followed by similar section for the clock.

-- 
With Best Regards,
Andy Shevchenko


Reply via email to