On 17. 09. 20 20:50, Krzysztof Kozlowski wrote: > GPIO_ACTIVE_x flags are not correct in the context of interrupt flags. > These are simple defines so they could be used in DTS but they will not > have the same meaning: > 1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE > 2. GPIO_ACTIVE_LOW = 1 = IRQ_TYPE_EDGE_RISING > > Correct the interrupt flags, assuming the author of the code wanted same > logical behavior behind the name "ACTIVE_xxx", this is: > ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW > > Signed-off-by: Krzysztof Kozlowski <[email protected]> > > --- > > Not tested on HW. > > Changes since v1: > 1. Correct title > --- > arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > index d60110ad8367..c9460693f4e9 100644 > --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > @@ -186,7 +186,7 @@ > compatible = "ti,tps65086"; > reg = <0x5e>; > interrupt-parent = <&gpio>; > - interrupts = <77 GPIO_ACTIVE_LOW>; > + interrupts = <77 IRQ_TYPE_LEVEL_LOW>; > #gpio-cells = <2>; > gpio-controller; > }; > Applied to https://github.com/Xilinx/linux-xlnx/tree/zynqmp/dt. M
