The PMIC's interrupt is level low and should be pulled up. The PMIC's device node had pinctrl-0 property but it lacked pinctrl-names which is required to apply the pin configuration. The actual problem in DTS was pointed out by Felix Radensky from Variscite.
Reported-by: Felix Radensky <[email protected]> Fixes: ade0176dd8a0 ("arm64: dts: imx8mn-var-som: Add Variscite VAR-SOM-MX8MN System on Module") Signed-off-by: Krzysztof Kozlowski <[email protected]> --- arch/arm64/boot/dts/freescale/imx8mn-var-som.dtsi | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-) diff --git a/arch/arm64/boot/dts/freescale/imx8mn-var-som.dtsi b/arch/arm64/boot/dts/freescale/imx8mn-var-som.dtsi index a2d0190921e4..7f356edf9f91 100644 --- a/arch/arm64/boot/dts/freescale/imx8mn-var-som.dtsi +++ b/arch/arm64/boot/dts/freescale/imx8mn-var-som.dtsi @@ -116,13 +116,10 @@ pmic@4b { compatible = "rohm,bd71847"; reg = <0x4b>; + pinctrl-names = "default"; pinctrl-0 = <&pinctrl_pmic>; interrupt-parent = <&gpio2>; - /* - * The interrupt is not correct. It should be level low, - * however with internal pull up this causes IRQ storm. - */ - interrupts = <8 IRQ_TYPE_EDGE_RISING>; + interrupts = <8 IRQ_TYPE_LEVEL_LOW>; rohm,reset-snvs-powered; regulators { @@ -388,7 +385,7 @@ pinctrl_pmic: pmicirqgrp { fsl,pins = < - MX8MN_IOMUXC_SD1_DATA6_GPIO2_IO8 0x101 + MX8MN_IOMUXC_SD1_DATA6_GPIO2_IO8 0x141 >; }; -- 2.17.1
