On Wednesday 21 November 2007, Oliver Neukum wrote: > Am Mittwoch 21 November 2007 schrieb Felipe Balbi: > > > Do you know any good way for performing a softreset within the driver? > > > The video application should get a continuous datastream after > > > resuming the notebook, so the driver shouldn't be unloaded. > > > The driver also keeps a list of previous camera settings which should > > > be set up again after resuming. Stopping the video application and > > > reattaching the device using ACPI (this board supports reconnecting > > > the device using ACPI) should be avoided. > > > > When you suspend, you cut off vbus (afaik, correct me if I'm wrong), > > which means your device will get disconnected. One way to avoid this is > > enabling CONFIG_USB_PERSIST and trying with that on. > > Suspend may or may not cut off power.
I've always been confused by this. If I'm not mistaken, there are three kind of suspend modes: autosuspend, suspend to RAM and suspend to disk. In the first case I expect the USB hub (either root hub or external hub) to make the bus idle but not power it down. In the last case I suspect the USB bus to be powered down. What controls the USB bus power on suspended ports ? Is it handled by the system (BIOS, ...) ? Is it allowed to power down the ports or keep them powered as it chooses ? What are the rules set in stone ? > If it does cut off power, resume() will never be called, instead either > disconnect() or reset_resume(). What is reset_resume() for ? Which one will be called on resume after a bus power down ? Best regards, Laurent Pinchart - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/