Hello, Le ven. 11 déc. 2020 à 15:04, Mark Brown <[email protected]> a écrit : > > On Thu, Dec 10, 2020 at 11:16:28PM +0100, Adrien Grassein wrote: > > Add a devicetree binding documentation for the pf8x00 regulator driver. > > Please don't send new patches in reply to old threads, it makes it hard > to keep track of what is going on.
Sorry. Should I create a new mail each time I send a new version of the patch? > > > + regulator-name: > > + pattern: "^ldo[1-4]$" > > + description: > > + should be ldo1", ..., "ldo4" > > This is part of the generic regulator binding and since it's for board > specific usage it should not be constrained by the chip binding. Ok. > > > + nxp,vselect-en: > > + $ref: /schemas/types.yaml#definitions/flag > > + description: > > + Only available for ldo2. When specified, use the VSELECT > > + input pin of the chip to control the output voltage of the > > + ldo02 regulator. (3.3V if VSELECT is LOW, 1.8V if HIGH). > > How is VSELECT used without a binding specifying some mechanism for > control? I think that VSELECT input should be controlled by the sub system that uses it (via maybe a GPIO). On my board, it's directly controlled by another chip (so without a GPIO). > > > + nxp,ilim-microamp: > > + $ref: /schemas/types.yaml#definitions/uint32 > > + minimum: 2100 > > + maximum: 4500 > > + default: 2100 > > + enum: [ 2100, 2600, 3000, 4500 ] > > + description: > > + Defines the maximum current delivered by the regulator in > > microamp. > > Instead of implementing a custom property this should use the already > existing properties for current limits, this is a common thing for > hardware to have so we shouldn't have custom bindings. We'll need to > relax the check the code currently has for a non-zero minimum limit but > otherwise everything should already be there. Ok I now use "regulator-max-microamp" property from the regulator that acts like my property. I was wrong with the default value. I re-read the documentation and the default value is stored in OTP memory. So if someone skipped this property, it's OK to not send any value. Thanks again, Regards,
