Correct ordering of phy_init and phy_power_on

[Ahmad Fatoum]

Hello,

I just noticed that USB controller drivers differ in the order in which they
do phy_init and phy_power_on. For example:

__dwc2_lowlevel_hw_enable():

        ret = phy_power_on(hsotg->phy);    
        if (ret == 0)                      
                ret = phy_init(hsotg->phy);

dwc3_core_init():

        ret = dwc3_core_soft_reset(dwc); // internally does 
phy_init(dwc->usb2_generic_phy);
        /* [snip] */
        ret = phy_power_on(dwc->usb2_generic_phy);


My initial assumption has been init -> power_on, but at least the 
phy-stm32-usbphyc
(used with dwc2) is written with the assumption that exit -> power_off (and 
therefore
power_on -> init). If they are swapped, disabling fails.

So how was it meant to be?

Cheers,
Ahmad

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |