On Fri, Jan 22, 2021 at 9:07 PM Dmitry Osipenko <dig...@gmail.com> wrote:
> According to datasheets, chips like mXT1386 have a WAKE line, it is used > to wake the chip up from deep sleep mode before communicating with it via > the I2C-compatible interface. > > If the WAKE line is connected to a GPIO line, the line must be asserted > 25 ms before the host attempts to communicate with the controller. If the > WAKE line is connected to the SCL pin, the controller will send a NACK on > the first attempt to address it, the host must then retry 25 ms later. > > Implement the wake-up methods in the driver. Touchscreen now works > properly on devices like Acer A500 tablet, fixing problems like this: > > atmel_mxt_ts 0-004c: __mxt_read_reg: i2c transfer failed (-121) > atmel_mxt_ts 0-004c: mxt_bootloader_read: i2c recv failed (-121) > atmel_mxt_ts 0-004c: Trying alternate bootloader address > atmel_mxt_ts 0-004c: mxt_bootloader_read: i2c recv failed (-121) > atmel_mxt_ts: probe of 0-004c failed with error -121 > > Signed-off-by: Jiada Wang <jiada_w...@mentor.com> > Signed-off-by: Dmitry Osipenko <dig...@gmail.com> Reviewed-by: Linus Walleij <linus.wall...@linaro.org> Yours, Linus Walleij
