On 2/1/21 2:04 AM, Paweł Chmiel wrote:
> This clock must be always enabled to allow access to any registers in
> fsys1 CMU. Until proper solution based on runtime PM is applied
> (similar to what was done for Exynos5433), fix this by calling
> clk_prepare_enable() directly from clock provider driver.
>
> It was observed on Samsung Galaxy S6 device (based on Exynos7420), where
> UFS module is probed before pmic used to power that device.
> In this case defer probe was happening and that clock was disabled by
> UFS driver, causing whole boot to hang on next CMU access.
>
> Signed-off-by: Paweł Chmiel <pawel.mikolaj.chm...@gmail.com>
> ---
> Changes from v2:
> - Avoid __clk_lookup() call when enabling clock
> Changes from v1:
> - Instead of marking clock as critical, enable it manually in driver.
> ---
> drivers/clk/samsung/clk-exynos7.c | 14 +++++++++++++-
> 1 file changed, 13 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/clk/samsung/clk-exynos7.c
> b/drivers/clk/samsung/clk-exynos7.c
> index c1ff715e960c..24d3fc5c5d0f 100644
> --- a/drivers/clk/samsung/clk-exynos7.c
> +++ b/drivers/clk/samsung/clk-exynos7.c
> @@ -6,6 +6,7 @@
>
> #include <linux/clk-provider.h>
> #include <linux/of.h>
> +#include <linux/clk.h>
>
> #include "clk.h"
> #include <dt-bindings/clock/exynos7-clk.h>
> @@ -570,7 +571,18 @@ static const struct samsung_cmu_info top1_cmu_info
> __initconst = {
>
> static void __init exynos7_clk_top1_init(struct device_node *np)
> {
> - samsung_cmu_register_one(np, &top1_cmu_info);
> + struct samsung_clk_provider *ctx;
> + struct clk_hw **hws;
> +
> + ctx = samsung_cmu_register_one(np, &top1_cmu_info);
> + if (!ctx)
> + return;
> + hws = ctx->clk_data.hws;
> +
> + /*
> + * Keep top FSYS1 aclk enabled permanently. It's required for CMU
> register access.
> + */
> + clk_prepare_enable(hws[CLK_ACLK_FSYS1_200]->clk);
> }
>
> CLK_OF_DECLARE(exynos7_clk_top1, "samsung,exynos7-clock-top1",
>
Acked-by: Chanwoo Choi <cw00.c...@samsung.com>
--
Best Regards,
Chanwoo Choi
Samsung Electronics
