SAMA7G5's I2S-MCC has 4 pairs of DIN/DOUT pins. Since TDM only uses a
single pair of pins for synchronous capture and playback, the controller
needs to be told which of the pair is connected. This can be mentioned
using the new "microchip,tdm-data-pair" property. The property is optional,
needed only if TDM is used, and if it's missing DIN/DOUT 0 pins will be
used by default.
Signed-off-by: Codrin Ciubotariu <codrin.ciubota...@microchip.com>
---
Changes in v2:
- changes are done to mchp-i2s-mcc.txt insted of mchp,i2s-mcc.yaml
Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt
b/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt
index 2180dbd9ea81..af8fe3e657df 100644
--- a/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt
+++ b/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt
@@ -19,7 +19,12 @@ Required properties:
Optional properties:
- pinctrl-0: Should specify pin control groups used for this controller.
- princtrl-names: Should contain only one value - "default".
-
+- microchip,tdm-data-pair: 8 bit value that represents the DIN/DOUT pair pins
+ which are used to receive/send TDM data. It is
optional
+ and it is only needed if the controller uses the TDM
+ mode. Not available for "microchip,sam9x60-i2smcc"
+ compatible. If it's not present, the default value
is 0,
+ so the DIN/DOUT 0 pins are used.
(1) : Only the peripheral clock is required. The generated clock is optional
and should be set mostly when Master Mode is required.
--
2.27.0
