Add registers and bits definitions for SAMA7G5's UDDRC and DDR3PHY. Signed-off-by: Claudiu Beznea <[email protected]> --- include/soc/at91/sama7-ddr.h | 80 ++++++++++++++++++++++++++++++++++++ 1 file changed, 80 insertions(+) create mode 100644 include/soc/at91/sama7-ddr.h
diff --git a/include/soc/at91/sama7-ddr.h b/include/soc/at91/sama7-ddr.h new file mode 100644 index 000000000000..f6542584ca13 --- /dev/null +++ b/include/soc/at91/sama7-ddr.h @@ -0,0 +1,80 @@ +/* SPDX-License-Identifier: GPL-2.0-only */ +/* + * Microchip SAMA7 UDDR Controller and DDR3 PHY Controller registers offsets + * and bit definitions. + * + * Copyright (C) [2020] Microchip Technology Inc. and its subsidiaries + * + * Author: Claudu Beznea <[email protected]> + */ + +#ifndef __SAMA7_DDR_H__ +#define __SAMA7_DDR_H__ + +#ifdef CONFIG_SOC_SAMA7 + +/* DDR3PHY */ +#define DDR3PHY_PIR (0x04) /* DDR3PHY PHY Initialization Register */ +#define DDR3PHY_PIR_DLLBYP (1 << 17) /* DLL Bypass */ +#define DDR3PHY_PIR_ITMSRST (1 << 4) /* Interface Timing Module Soft Reset */ +#define DDR3PHY_PIR_DLLLOCK (1 << 2) /* DLL Lock */ +#define DDR3PHY_PIR_DLLSRST (1 << 1) /* DLL Soft Rest */ +#define DDR3PHY_PIR_INIT (1 << 0) /* Initialization Trigger */ + +#define DDR3PHY_PGCR (0x08) /* DDR3PHY PHY General Configuration Register */ +#define DDR3PHY_PGCR_CKDV1 (1 << 13) /* CK# Disable Value */ +#define DDR3PHY_PGCR_CKDV0 (1 << 12) /* CK Disable Value */ + +#define DDR3PHY_PGSR (0x0C) /* DDR3PHY PHY General Status Register */ +#define DDR3PHY_PGSR_IDONE (1 << 0) /* Initialization Done */ + +#define DDR3PHY_ACIOCR (0x24) /* DDR3PHY AC I/O Configuration Register */ +#define DDR3PHY_ACIOCR_CSPDD_CS0 (1 << 18) /* CS#[0] Power Down Driver */ +#define DDR3PHY_ACIOCR_CKPDD_CK0 (1 << 8) /* CK[0] Power Down Driver */ +#define DDR3PHY_ACIORC_ACPDD (1 << 3) /* AC Power Down Driver */ + +#define DDR3PHY_DXCCR (0x28) /* DDR3PHY DATX8 Common Configuration Register */ +#define DDR3PHY_DXCCR_DXPDR (1 << 3) /* Data Power Down Receiver */ + +#define DDR3PHY_DSGCR (0x2C) /* DDR3PHY DDR System General Configuration Register */ +#define DDR3PHY_DSGCR_ODTPDD_ODT0 (1 << 20) /* ODT[0] Power Down Driver */ + +#define DDR3PHY_ZQ0SR0 (0x188) /* ZQ status register 0 */ + +/* UDDRC */ +#define UDDRC_STAT (0x04) /* UDDRC Operating Mode Status Register */ +#define UDDRC_STAT_SELFREF_TYPE_DIS (0x0 << 4) /* SDRAM is not in Self-refresh */ +#define UDDRC_STAT_SELFREF_TYPE_PHY (0x1 << 4) /* SDRAM is in Self-refresh, which was caused by PHY Master Request */ +#define UDDRC_STAT_SELFREF_TYPE_SW (0x2 << 4) /* SDRAM is in Self-refresh, which was not caused solely under Automatic Self-refresh control */ +#define UDDRC_STAT_SELFREF_TYPE_AUTO (0x3 << 4) /* SDRAM is in Self-refresh, which was caused by Automatic Self-refresh only */ +#define UDDRC_STAT_SELFREF_TYPE_MSK (0x3 << 4) /* Self-refresh type mask */ +#define UDDRC_STAT_OPMODE_INIT (0x0 << 0) /* Init */ +#define UDDRC_STAT_OPMODE_NORMAL (0x1 << 0) /* Normal */ +#define UDDRC_STAT_OPMODE_PWRDOWN (0x2 << 0) /* Power-down */ +#define UDDRC_STAT_OPMODE_SELF_REFRESH (0x3 << 0) /* Self-refresh */ +#define UDDRC_STAT_OPMODE_MSK (0x7 << 0) /* Operating mode mask */ + +#define UDDRC_PWRCTL (0x30) /* UDDRC Low Power Control Register */ +#define UDDRC_PWRCTRL_SELFREF_SW (1 << 5) /* Software self-refresh */ + +#define UDDRC_DFIMISC (0x1B0) /* UDDRC DFI Miscellaneous Control Register */ +#define UDDRC_DFIMISC_DFI_INIT_COMPLETE_EN (1 << 0) /* PHY initialization complete enable signal */ + +#define UDDRC_SWCTRL (0x320) /* UDDRC Software Register Programming Control Enable */ +#define UDDRC_SWCTRL_SW_DONE (1 << 0) /* Enable quasi-dynamic register programming outside reset */ + +#define UDDRC_SWSTAT (0x324) /* UDDRC Software Register Programming Control Status */ +#define UDDRC_SWSTAT_SW_DONE_ACK (1 << 0) /* Register programming done */ + +#define UDDRC_PSTAT (0x3FC) /* UDDRC Port Status Register */ +#define UDDRC_PSTAT_ALL_PORTS (0x1F001F) /* Read + writes outstanding transactions on all ports */ + +#define UDDRC_PCTRL_0 (0x490) /* UDDRC Port 0 Control Register */ +#define UDDRC_PCTRL_1 (0x540) /* UDDRC Port 1 Control Register */ +#define UDDRC_PCTRL_2 (0x5F0) /* UDDRC Port 2 Control Register */ +#define UDDRC_PCTRL_3 (0x6A0) /* UDDRC Port 3 Control Register */ +#define UDDRC_PCTRL_4 (0x750) /* UDDRC Port 4 Control Register */ + +#endif /* CONFIG_SOC_SAMA7 */ + +#endif /* __SAMA7_DDR_H__ */ -- 2.25.1
