Setting 10G without autonegotiation is invalid according to
phy_ethtool_ksettings_set(). Thus, we need to set it during
autonegotiation.

If 1G autonegotiation can't complete for quite a time, but there is
signal in line, switch line interface type to 10GBase-R, if supported,
in hope for link to be established.

And vice versa. If 10GBase-R link can't be established for quite a time,
and autonegotiation is enabled, and there is signal in line, switch line
interface type to appropriate 1G mode, i.e. 1000Base-X or SGMII, if
supported.

Signed-off-by: Ivan Bornyakov <i.bornya...@metrotek.ru>
---
 drivers/net/phy/marvell-88x2222.c | 117 +++++++++++++++++++++++-------
 1 file changed, 89 insertions(+), 28 deletions(-)

diff --git a/drivers/net/phy/marvell-88x2222.c 
b/drivers/net/phy/marvell-88x2222.c
index 640b133f1371..9b9ac3ef735d 100644
--- a/drivers/net/phy/marvell-88x2222.c
+++ b/drivers/net/phy/marvell-88x2222.c
@@ -52,6 +52,8 @@
 #define        MV_1GBX_PHY_STAT_SPEED100       BIT(14)
 #define        MV_1GBX_PHY_STAT_SPEED1000      BIT(15)
 
+#define        AUTONEG_TIMEOUT 3
+
 struct mv2222_data {
        phy_interface_t line_interface;
        __ETHTOOL_DECLARE_LINK_MODE_MASK(supported);
@@ -173,6 +175,24 @@ static bool mv2222_is_1gbx_capable(struct phy_device 
*phydev)
                                 priv->supported);
 }
 
+static bool mv2222_is_sgmii_capable(struct phy_device *phydev)
+{
+       struct mv2222_data *priv = phydev->priv;
+
+       return (linkmode_test_bit(ETHTOOL_LINK_MODE_1000baseT_Full_BIT,
+                                 priv->supported) ||
+               linkmode_test_bit(ETHTOOL_LINK_MODE_1000baseT_Half_BIT,
+                                 priv->supported) ||
+               linkmode_test_bit(ETHTOOL_LINK_MODE_100baseT_Full_BIT,
+                                 priv->supported) ||
+               linkmode_test_bit(ETHTOOL_LINK_MODE_100baseT_Half_BIT,
+                                 priv->supported) ||
+               linkmode_test_bit(ETHTOOL_LINK_MODE_10baseT_Full_BIT,
+                                 priv->supported) ||
+               linkmode_test_bit(ETHTOOL_LINK_MODE_10baseT_Half_BIT,
+                                 priv->supported));
+}
+
 static int mv2222_config_line(struct phy_device *phydev)
 {
        struct mv2222_data *priv = phydev->priv;
@@ -192,7 +212,8 @@ static int mv2222_config_line(struct phy_device *phydev)
        }
 }
 
-static int mv2222_setup_forced(struct phy_device *phydev)
+/* Switch between 1G (1000Base-X/SGMII) and 10G (10GBase-R) modes */
+static int mv2222_swap_line_type(struct phy_device *phydev)
 {
        struct mv2222_data *priv = phydev->priv;
        bool changed = false;
@@ -200,25 +221,23 @@ static int mv2222_setup_forced(struct phy_device *phydev)
 
        switch (priv->line_interface) {
        case PHY_INTERFACE_MODE_10GBASER:
-               if (phydev->speed == SPEED_1000 &&
-                   mv2222_is_1gbx_capable(phydev)) {
+               if (mv2222_is_1gbx_capable(phydev)) {
                        priv->line_interface = PHY_INTERFACE_MODE_1000BASEX;
                        changed = true;
                }
 
-               break;
-       case PHY_INTERFACE_MODE_1000BASEX:
-               if (phydev->speed == SPEED_10000 &&
-                   mv2222_is_10g_capable(phydev)) {
-                       priv->line_interface = PHY_INTERFACE_MODE_10GBASER;
+               if (mv2222_is_sgmii_capable(phydev)) {
+                       priv->line_interface = PHY_INTERFACE_MODE_SGMII;
                        changed = true;
                }
 
                break;
+       case PHY_INTERFACE_MODE_1000BASEX:
        case PHY_INTERFACE_MODE_SGMII:
-               ret = mv2222_set_sgmii_speed(phydev);
-               if (ret < 0)
-                       return ret;
+               if (mv2222_is_10g_capable(phydev)) {
+                       priv->line_interface = PHY_INTERFACE_MODE_10GBASER;
+                       changed = true;
+               }
 
                break;
        default:
@@ -231,6 +250,29 @@ static int mv2222_setup_forced(struct phy_device *phydev)
                        return ret;
        }
 
+       return 0;
+}
+
+static int mv2222_setup_forced(struct phy_device *phydev)
+{
+       struct mv2222_data *priv = phydev->priv;
+       int ret;
+
+       if (priv->line_interface == PHY_INTERFACE_MODE_10GBASER) {
+               if (phydev->speed < SPEED_10000 &&
+                   phydev->speed != SPEED_UNKNOWN) {
+                       ret = mv2222_swap_line_type(phydev);
+                       if (ret < 0)
+                               return ret;
+               }
+       }
+
+       if (priv->line_interface == PHY_INTERFACE_MODE_SGMII) {
+               ret = mv2222_set_sgmii_speed(phydev);
+               if (ret < 0)
+                       return ret;
+       }
+
        return mv2222_disable_aneg(phydev);
 }
 
@@ -244,17 +286,9 @@ static int mv2222_config_aneg(struct phy_device *phydev)
                return 0;
 
        if (phydev->autoneg == AUTONEG_DISABLE ||
-           phydev->speed == SPEED_10000)
+           priv->line_interface == PHY_INTERFACE_MODE_10GBASER)
                return mv2222_setup_forced(phydev);
 
-       if (priv->line_interface == PHY_INTERFACE_MODE_10GBASER &&
-           mv2222_is_1gbx_capable(phydev)) {
-               priv->line_interface = PHY_INTERFACE_MODE_1000BASEX;
-               ret = mv2222_config_line(phydev);
-               if (ret < 0)
-                       return ret;
-       }
-
        adv = linkmode_adv_to_mii_adv_x(priv->supported,
                                        ETHTOOL_LINK_MODE_1000baseX_Full_BIT);
 
@@ -291,6 +325,7 @@ static int mv2222_aneg_done(struct phy_device *phydev)
 /* Returns negative on error, 0 if link is down, 1 if link is up */
 static int mv2222_read_status_10g(struct phy_device *phydev)
 {
+       static int timeout;
        int val, link = 0;
 
        val = phy_read_mmd(phydev, MDIO_MMD_PCS, MDIO_STAT1);
@@ -304,6 +339,20 @@ static int mv2222_read_status_10g(struct phy_device 
*phydev)
                phydev->autoneg = AUTONEG_DISABLE;
                phydev->speed = SPEED_10000;
                phydev->duplex = DUPLEX_FULL;
+       } else {
+               if (phydev->autoneg == AUTONEG_ENABLE) {
+                       timeout++;
+
+                       if (timeout > AUTONEG_TIMEOUT) {
+                               timeout = 0;
+
+                               val = mv2222_swap_line_type(phydev);
+                               if (val < 0)
+                                       return val;
+
+                               return mv2222_config_aneg(phydev);
+                       }
+               }
        }
 
        return link;
@@ -312,15 +361,31 @@ static int mv2222_read_status_10g(struct phy_device 
*phydev)
 /* Returns negative on error, 0 if link is down, 1 if link is up */
 static int mv2222_read_status_1g(struct phy_device *phydev)
 {
+       static int timeout;
        int val, link = 0;
 
        val = phy_read_mmd(phydev, MDIO_MMD_PCS, MV_1GBX_STAT);
        if (val < 0)
                return val;
 
-       if (!(val & BMSR_LSTATUS) ||
-           (phydev->autoneg == AUTONEG_ENABLE &&
-            !(val & BMSR_ANEGCOMPLETE)))
+       if (phydev->autoneg == AUTONEG_ENABLE &&
+           !(val & BMSR_ANEGCOMPLETE)) {
+               timeout++;
+
+               if (timeout > AUTONEG_TIMEOUT) {
+                       timeout = 0;
+
+                       val = mv2222_swap_line_type(phydev);
+                       if (val < 0)
+                               return val;
+
+                       return mv2222_config_aneg(phydev);
+               }
+
+               return 0;
+       }
+
+       if (!(val & BMSR_LSTATUS))
                return 0;
 
        link = 1;
@@ -447,11 +512,7 @@ static int mv2222_sfp_insert(void *upstream, const struct 
sfp_eeprom_id *id)
                return ret;
 
        if (mutex_trylock(&phydev->lock)) {
-               if (priv->line_interface == PHY_INTERFACE_MODE_10GBASER)
-                       ret = mv2222_setup_forced(phydev);
-               else
-                       ret = mv2222_config_aneg(phydev);
-
+               ret = mv2222_config_aneg(phydev);
                mutex_unlock(&phydev->lock);
        }
 
-- 
2.26.3


Reply via email to