Re: [PATCH v7 6/6] remoteproc: qcom: enable in-kernel PD mapper

[Chris Lew]

On 4/24/2024 2:28 AM, Dmitry Baryshkov wrote:
diff --git a/drivers/remoteproc/qcom_q6v5_adsp.c 
b/drivers/remoteproc/qcom_q6v5_adsp.c
index 1d24c9b656a8..02d0c626b03b 100644
--- a/drivers/remoteproc/qcom_q6v5_adsp.c
+++ b/drivers/remoteproc/qcom_q6v5_adsp.c
@@ -23,6 +23,7 @@
  #include <linux/remoteproc.h>
  #include <linux/reset.h>
  #include <linux/soc/qcom/mdt_loader.h>
+#include <linux/soc/qcom/pd_mapper.h>
  #include <linux/soc/qcom/smem.h>
  #include <linux/soc/qcom/smem_state.h>
  
@@ -375,10 +376,14 @@ static int adsp_start(struct rproc *rproc)
        int ret;
        unsigned int val;
  
-	ret = qcom_q6v5_prepare(&adsp->q6v5);
+       ret = qcom_pdm_get();
        if (ret)
                return ret;

Would it make sense to try and model this as a rproc subdev? This 
section of the remoteproc code seems to be focused on making specific 
calls to setup and enable hardware resources, where as pd mapper is 
software.

sysmon and ssr are also purely software and they are modeled as subdevs 
in qcom_common. I'm not an expert on remoteproc organization but this 
was just a thought.

Thanks!
Chris

  
+	ret = qcom_q6v5_prepare(&adsp->q6v5);
+       if (ret)
+               goto put_pdm;
+
        ret = adsp_map_carveout(rproc);
        if (ret) {
                dev_err(adsp->dev, "ADSP smmu mapping failed\n");
@@ -446,6 +451,8 @@ static int adsp_start(struct rproc *rproc)
        adsp_unmap_carveout(rproc);
  disable_irqs:
        qcom_q6v5_unprepare(&adsp->q6v5);
+put_pdm:
+       qcom_pdm_release();
  
  	return ret;
  }