On Monday, 21 July 2025 16:35:41 Central European Summer Time Rob Herring wrote: > On Fri, Jul 18, 2025 at 11:12:38PM +0200, Duje Mihanović wrote: > > On the pxav3 controller, increasing the drive strength of the data pins > > might be required to maintain stability on fast bus clocks (above 100 > > MHz). Add a state_uhs pinctrl to allow this. > > > > The existing state_cmd_gpio pinctrl is changed to apply only on pxav1 as > > it's unneeded on the other controllers. > > > > Signed-off-by: Duje Mihanović <d...@dujemihanovic.xyz> > > --- > > > > .../devicetree/bindings/mmc/sdhci-pxa.yaml | 45 > > +++++++++++++++++----- 1 file changed, 35 insertions(+), 10 deletions(-) > > > > diff --git a/Documentation/devicetree/bindings/mmc/sdhci-pxa.yaml > > b/Documentation/devicetree/bindings/mmc/sdhci-pxa.yaml index > > 4869ddef36fd89265a1bfe96bb9663b553ac5084..7a9e2a63ac4351aea10b2763ca250ce48 > > 89df1eb 100644 --- a/Documentation/devicetree/bindings/mmc/sdhci-pxa.yaml > > +++ b/Documentation/devicetree/bindings/mmc/sdhci-pxa.yaml > > > > @@ -30,6 +30,39 @@ allOf: > > maxItems: 1 > > > > reg-names: > > maxItems: 1 > > > > + - if: > > + properties: > > + compatible: > > + contains: > > + const: mrvl,pxav1-mmc > > + then: > > + properties: > > + pinctrl-names: > > + description: > > + Optional for supporting PXA168 SDIO IRQ errata to switch CMD > > pin between + SDIO CMD and GPIO mode. > > + items: > > + - const: default > > + - const: state_cmd_gpio > > blank line
While at it, should I do the same with the properties: blocks in the existing if: block? Regards, -- Duje
