This patchset serves as a preparing patchset for i.MX95 support.
The current code logic is complicated, with mix the usage of switch-case
and if-else.
To simplify the code logic:
Introduce struct imx_rproc_plat_ops to wrap platform start,stop,detect_mode.
Each imx_rproc_dcfg data structure is assigned a ops pointer.
The common imx_rproc_{start,stop}() directly invokes the plat ops, no
need the switch-case.
mmio/smc/scu_api ops are included.
No functional changes.
Thanks to Daniel and Frank for the help.
Test on i.MX8MM for MMIO ops, i.MX8MP for SMC ops. For SCU-API ops,
I currently not have a setup at hand, I will give a setup and test
later, but everything should be fine, no functional changes.
Signed-off-by: Peng Fan <peng....@nxp.com>
---
Peng Fan (6):
remoteproc: imx_rproc: Introduce start/stop/detect_mode ops for
imx_rproc_dcfg
remoteproc: imx_rproc: Move imx_rproc_dcfg closer to imx_rproc_of_match
remoteproc: imx_rproc: Simplify IMX_RPROC_MMIO switch case
remoteproc: imx_rproc: Simplify IMX_RPROC_SCU_API switch case
remoteproc: imx_rproc: Simplify IMX_RPROC_SMC switch case
remoteproc: imx_rproc: Clean up after ops introduction
drivers/remoteproc/imx_rproc.c | 448 +++++++++++++++++++++++------------------
drivers/remoteproc/imx_rproc.h | 7 +
2 files changed, 264 insertions(+), 191 deletions(-)
---
base-commit: 3e8e5822146bc396d2a7e5fbb7be13271665522a
change-id: 20250908-imx-rproc-cleanup-6f3b546b9fdf
Best regards,
--
Peng Fan <peng....@nxp.com>
