Add a node for the Hall Effect sensor, used to detect whether the Flip Cover is closed or not.
The sensor is powered through vreg_l10b, so let's put a regulator-always-on on that to make sure the sensor gets power. Signed-off-by: Luca Weiss <[email protected]> --- As pointed out in v1, this would preferably go via some vdd-supply to gpio-keys, but this support does not exist yet. --- Changes in v2: - Add pinctrl for gpio70 - Link to v1: https://lore.kernel.org/r/[email protected] --- arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts | 21 ++++++++++++++++++++- 1 file changed, 20 insertions(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts b/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts index 7629ceddde2a..bba327cc7a38 100644 --- a/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts +++ b/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts @@ -29,9 +29,19 @@ aliases { gpio-keys { compatible = "gpio-keys"; - pinctrl-0 = <&volume_up_default>; + pinctrl-0 = <&volume_up_default>, <&hall_sensor_default>; pinctrl-names = "default"; + /* Powered by the always-on vreg_l10b */ + event-hall-sensor { + label = "Hall Effect Sensor"; + gpios = <&tlmm 70 GPIO_ACTIVE_LOW>; + linux,input-type = <EV_SW>; + linux,code = <SW_LID>; + linux,can-disable; + wakeup-source; + }; + key-volume-up { label = "Volume Up"; gpios = <&pm7550_gpios 6 GPIO_ACTIVE_LOW>; @@ -316,6 +326,8 @@ vreg_l10b: ldo10 { regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>; + /* Hall sensor VDD */ + regulator-always-on; }; vreg_l11b: ldo11 { @@ -807,6 +819,13 @@ sdc2_card_det_n: sdc2-card-det-state { bias-pull-up; }; + hall_sensor_default: hall-sensor-default-state { + pins = "gpio70"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + }; + pm8008_int_default: pm8008-int-default-state { pins = "gpio125"; function = "gpio"; --- base-commit: 3daf23347bb5f4a375d0101ed29c97ce1a99721b change-id: 20260116-fp6-hall-sensor-1049f2f872ac Best regards, -- Luca Weiss <[email protected]>
