Configure the MDSS nodes for the phone and add the panel node.
Signed-off-by: Luca Weiss <[email protected]>
---
arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts | 64 ++++++++++++++++++++++++
1 file changed, 64 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts
b/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts
index 48e87bd8ec2f..a6c467a27d09 100644
--- a/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts
+++ b/arch/arm64/boot/dts/qcom/milos-fairphone-fp6.dts
@@ -690,6 +690,49 @@ vreg_l7p: ldo7 {
/* AW86938FCR vibrator @ 0x5a */
};
+&mdss {
+ status = "okay";
+};
+
+&mdss_dsi0 {
+ vdda-supply = <&vreg_l4b>;
+
+ status = "okay";
+
+ panel@0 {
+ compatible = "boe,bj631jhm-t71-d900";
+ reg = <0>;
+
+ reset-gpios = <&tlmm 12 GPIO_ACTIVE_LOW>;
+
+ vci-supply = <&vreg_l19b>;
+ vddio-supply = <&vreg_l9b>;
+ dvdd-supply = <&vreg_oled_dvdd_1p2>;
+
+ pinctrl-0 = <&disp_reset_n_active>, <&mdp_vsync>;
+ pinctrl-1 = <&disp_reset_n_suspend>, <&mdp_vsync>;
+ pinctrl-names = "default",
+ "sleep";
+
+ port {
+ panel_in: endpoint {
+ remote-endpoint = <&mdss_dsi0_out>;
+ };
+ };
+ };
+};
+
+&mdss_dsi0_out {
+ data-lanes = <0 1 2 3>;
+ remote-endpoint = <&panel_in>;
+};
+
+&mdss_dsi0_phy {
+ vdds-supply = <&vreg_l2b>;
+
+ status = "okay";
+};
+
&pm8550vs_c {
status = "okay";
};
@@ -848,6 +891,20 @@ &tlmm {
<13 1>, /* NC */
<63 2>; /* WLAN UART */
+ disp_reset_n_active: disp-reset-n-active-state {
+ pins = "gpio12";
+ function = "gpio";
+ drive-strength = <8>;
+ bias-disable;
+ };
+
+ disp_reset_n_suspend: disp-reset-n-suspend-state {
+ pins = "gpio12";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+
sdc2_card_det_n: sdc2-card-det-state {
pins = "gpio65";
function = "gpio";
@@ -868,6 +925,13 @@ pm8008_int_default: pm8008-int-default-state {
drive-strength = <2>;
bias-disable;
};
+
+ mdp_vsync: mdp-vsync-state {
+ pins = "gpio129";
+ function = "mdp_vsync";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
};
&uart5 {
--
2.54.0
