virtnet_poll_cleantx() contains a do-while loop that cleans up
transmitted TX buffers and calls virtqueue_enable_cb_delayed() to check
whether more buffers need processing. When the virtio backend stops
responding during guest reboot, used->idx is never updated, so
virtqueue_enable_cb_delayed() always returns false and the loop never
terminates. Then it will block reboot process, and the guest will hang.
The problem occurs during guest reboot under network traffic:
1. kernel_restart() -> device_shutdown() traverses the device list
2. virtio_dev_shutdown() calls virtio_break_device() which sets
vq->broken = true
3. virtio_dev_shutdown() then calls virtio_synchronize_cbs() to wait
for in-flight callbacks to complete
4. A virtio interrupt fires, softirq is deferred to ksoftirqd which
calls net_rx_action() -> virtnet_poll() -> virtnet_poll_cleantx()
5. virtnet_poll_cleantx() enters the do-while loop and never exits
because the QEMU backend has stopped updating used->idx, despite
vq->broken having been set to true in step 2.
Since the loop runs inside ksoftirqd (a SCHED_OTHER kthread), it is
visible to the scheduler and does not trigger a hard lockup. However,
the kthread never leaves the loop, so RCU detects it as a CPU stall
and reports it periodically. Meanwhile, the reboot process remains
blocked in device_shutdown() because virtio_dev_shutdown() cannot
complete its synchronization step, and the guest hangs permanently.
This can be reproduced on a guest with a virtio-net device: run iperf3
traffic in the guest, then trigger reboot. The reboot occasionally hangs
permanently with RCU stall on ksoftirqd.
Observed on ARM64 KVM guest:
CPU#1 RCU stall (ksoftirqd/1), repeated periodically:
virtqueue_enable_cb_delayed_split <- virtnet_poll <- __napi_poll <-
net_rx_action <- handle_softirqs <- run_ksoftirqd <-
smpboot_thread_fn <- kthread
Fix by adding a virtqueue_is_broken() check to the loop condition, so
that the loop exits immediately when the device is broken, allowing
the device shutdown to proceed.
Signed-off-by: Jinqian Yang <[email protected]>
---
Changes in v2:
- Moved vq->broken check to virtqueue_enable_cb_delayed().
v1:
https://lore.kernel.org/lkml/[email protected]/
---
drivers/virtio/virtio_ring.c | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/drivers/virtio/virtio_ring.c b/drivers/virtio/virtio_ring.c
index b438dc2ce1b8..5c169fbb418a 100644
--- a/drivers/virtio/virtio_ring.c
+++ b/drivers/virtio/virtio_ring.c
@@ -3233,6 +3233,14 @@ bool virtqueue_enable_cb_delayed(struct virtqueue *_vq)
{
struct vring_virtqueue *vq = to_vvq(_vq);
+ /*
+ * When the device is broken there is no point in polling used->idx,
+ * the backend will never update it. Return true to let callers
+ * exit their cleanup loops instead of spinning forever.
+ */
+ if (unlikely(vq->broken))
+ return true;
+
if (vq->event_triggered)
data_race(vq->event_triggered = false);
--
2.33.0
