Thank you so much for the review, David!

Alex, does this series look good to you?

On Fri, Jul 24, 2026 at 2:42 PM David Matlack <[email protected]> wrote:
>
> On 2026-07-22 12:15 AM, Josh Hilke wrote:
> > This v6 of a series which adds a VFIO selftest driver for the Intel
> > Gigabit Ethernet controller (IGB), specifically targeting the 82576
> > device. IGB is fully virtualized in QEMU, making it suitable for running
> > VFIO selftests without specialized hardware.
>
> > Testing
> > =======
> > - VFIO selftests builds clean at every commit
> > - vfio_pci_driver_test passes using IGB driver + QEMU. Use the following
> >   command to run the tests:
> >
> >   vng \
> >   --run arch/x86/boot/bzImage \
> >   --user root \
> >   --disable-microvm \
> >   --memory 32G \
> >   --cpus 8 \
> >   --qemu-opts="-M q35,accel=kvm,kernel-irqchip=split" \
> >   --qemu-opts="-device 
> > intel-iommu,intremap=on,caching-mode=on,device-iotlb=on" \
> >   --qemu-opts="-netdev user,id=net0 -device igb,netdev=net0,addr=09.0" \
> >   --append "console=ttyS0 earlyprintk=ttyS0 intel_iommu=on iommu=pt" \
> >   --exec "modprobe vfio-pci && \
> >           ./tools/testing/selftests/vfio/scripts/setup.sh 0000:00:09.0 && \
> >           ./tools/testing/selftests/vfio/scripts/run.sh 
> > ./tools/testing/selftests/vfio/vfio_pci_driver_test"
>
> Extending this, you can run all VFIO selftests like this:
>
> make -C tools/testing/selftests TARGETS=vfio install
> vng \
>         ...
>         --append="hugepagesz=2M hugepages=1 hugepagesz=1G hugepages=1" \
>         --exec "
>                 tools/testing/selftests/vfio/scripts/setup.sh 0000:00:09.0 &&
>                 export VFIO_SELFTESTS_BDF=0000:00:09.0 &&
>                 cd tools/testing/selftests/kselftest_install &&
>                 ./run_kselftest.sh -o 360 -c vfio
>         "
>
> The --append flag makes sure there are HugeTLB pages allocated for
> vfio_dma_mapping_test. The "-o 360" is needed because
> vfio_pci_driver_test takes more than 45 seconds.
>
> > Alex Williamson (4):
> >       vfio: selftests: igb: Use PHY internal loopback on 82576
> >       vfio: selftests: Add helpers to re-enable interrupts
> >       vfio: selftests: igb: Factor hardware programming into igb_hw_init()
> >       vfio: selftests: igb: Recover after DMA-read faults
> >
> > Josh Hilke (2):
> >       vfio: selftests: igb: Add driver for Intel 82576 device
> >       vfio: selftests: Retry on EAGAIN during device reset
>
> Reviewed-by: David Matlack <[email protected]>
>
> Thanks!

Reply via email to