On 05/08/2026 07:21, Dmitry Torokhov wrote:
Hi David,
On Fri, Jul 31, 2026 at 08:13:40PM +0200, David Heidelberg via B4 Relay wrote:
This series ensures, that when invalid value is detected or mismatch
between value defined in the device-tree and the read from the
touchscreen is observed, the user is notified and zero is ignored.
This seems very complicated. If board maker specifies these parameters,
they probably want to use them instead of what the firmware reports. So
wouldn't it be simpler to not try to match and report differences but
rather skip querying hardware and use device properties if they are
specified?
Hi Dmitry.
Agree, I'll send next version just overriding the HW reported values.
David
Thanks.
--
David Heidelberg
