The integrated LAN on Intel boards with i815 chipset
apparently is not fully supported. In latest 2.2.x and 2.4.x,
with the EtherExpress Pro100 driver, after some network traffic,
it locks. The only way I can use the net again is either reboot,
or ifconfig eth0 down; ifconfig eth0 up.
I attached the syslog output;
The driver detects the chip as 82562EM although the mainboard
manual states that it has an integrated i82562ET chip.
Board: Intel D815EEA with onboard LAN, video,audio
----
eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V.
Savochkin <[EMAIL PROTECTED]> and others
eepro100.c: VA Linux custom, Dragan Stancevic <[EMAIL PROTECTED]>
2000/11/15
eth0: Intel PCI EtherExpress Pro100 82562EM, 00:03:47:48:7E:41, IRQ 11.
Board assembly 000000-000, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x04f4518b).
eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V.
Savochkin <[EMAIL PROTECTED]> and others
eepro100.c: VA Linux custom, Dragan Stancevic <[EMAIL PROTECTED]>
2000/11/15
---
Any idea why this happens?
P.S Please cc-me, I'm not subscribed to the list.
Feb 17 17:35:51 banica kernel: eepro100: wait_for_cmd_done timeout!
Feb 17 17:36:00 banica last message repeated 2 times
Feb 17 17:37:04 banica last message repeated 9 times
Feb 17 17:37:23 banica kernel: memory : c7a70720
Feb 17 17:37:23 banica kernel: memory : 00000000
Feb 17 17:37:23 banica kernel: memory : c7a70760
Feb 17 17:39:27 banica kernel: eepro100: wait_for_cmd_done timeout!
Feb 17 17:39:37 banica last message repeated 7 times
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out: status 0050 0cf0 at 119493/119521 command 000c0000.
eth0: Tx ring dump, Tx queue 119521 / 119493:
eth0: 0 600c0000.
eth0: = 1 000ca000.
eth0: 2 000ca000.
eth0: 3 000ca000.
eth0: 4 000ca000.
eth0: * 5 000c0000.
eth0: 6 000c0000.
eth0: 7 000c0000.
eth0: 8 200c0000.
eth0: 9 000c0000.
eth0: 10 000c0000.
eth0: 11 000c0000.
eth0: 12 000c0000.
eth0: 13 000c0000.
eth0: 14 000c0000.
eth0: 15 000c0000.
eth0: 16 200c0000.
eth0: 17 000c0000.
eth0: 18 000c0000.
eth0: 19 000c0000.
eth0: 20 000c0000.
eth0: 21 000c0000.
eth0: 22 000c0000.
eth0: 23 000c0000.
eth0: 24 200c0000.
eth0: 25 000c0000.
eth0: 26 000c0000.
eth0: 27 000c0000.
eth0: 28 000c0000.
eth0: 29 000c0000.
eth0: 30 000c0000.
eth0: 31 000c0000.
eth0: Printing Rx ring (next to receive into 161286, dirty index 161286).
eth0: 0 00000001.
eth0: 1 00000001.
eth0: 2 00000001.
eth0: 3 00000001.
eth0: 4 00000001.
eth0: l 5 c0000001.
eth0: *= 6 00000001.
eth0: 7 00000001.
eth0: 8 00000001.
eth0: 9 00000001.
eth0: 10 00000001.
eth0: 11 00000001.
eth0: 12 00000001.
eth0: 13 00000001.
eth0: 14 00000001.
eth0: 15 00000001.
eth0: 16 00000001.
eth0: 17 00000001.
eth0: 18 00000001.
eth0: 19 00000001.
eth0: 20 00000001.
eth0: 21 00000001.
eth0: 22 00000001.
eth0: 23 00000001.
eth0: 24 00000001.
eth0: 25 00000001.
eth0: 26 00000001.
eth0: 27 00000001.
eth0: 28 00000001.
eth0: 29 00000001.
eth0: 30 00000001.
eth0: 31 00000001.
eepro100: wait_for_cmd_done timeout!
-------------
Feb 17 17:49:39 banica kernel: eepro100: cmd_wait for(0xffffff80) timedout
with(0xffffff80)!
Feb 17 17:50:12 banica last message repeated 29 times
Feb 17 17:50:53 banica last message repeated 8 times
Feb 17 17:52:26 banica last message repeated 4 times
Feb 17 17:52:37 banica kernel: eepro100: cmd_wait for(0xfffffff0) timedout
with(0xfffffff0)!
