Correct spelling typo in Documentation/hwmon
Signed-off-by: Masanari Iida <[email protected]>
---
Documentation/hwmon/adt7410 | 2 +-
Documentation/hwmon/sht15 | 2 +-
Documentation/hwmon/zl6100 | 2 +-
3 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/Documentation/hwmon/adt7410 b/Documentation/hwmon/adt7410
index 58150c4..bb6a4f3 100644
--- a/Documentation/hwmon/adt7410
+++ b/Documentation/hwmon/adt7410
@@ -27,7 +27,7 @@ temperature set point has been exceeded. Both pins can be set
up with a common
hysteresis of 0??C - 15??C and a fault queue, ranging from 1 to 4 events. Both
pins can individually set to be active-low or active-high, while the whole
device can either run in comparator mode or interrupt mode. The ADT7410
-supports continous temperature sampling, as well as sampling one temperature
+supports continuous temperature sampling, as well as sampling one temperature
value per second or even justget one sample on demand for power saving.
Besides, it can completely power down its ADC, if power management is
required.
diff --git a/Documentation/hwmon/sht15 b/Documentation/hwmon/sht15
index 02850bd..778987d 100644
--- a/Documentation/hwmon/sht15
+++ b/Documentation/hwmon/sht15
@@ -40,7 +40,7 @@ bits for humidity, or 12 bits for temperature and 8 bits for
humidity.
The humidity calibration coefficients are programmed into an OTP memory on the
chip. These coefficients are used to internally calibrate the signals from the
sensors. Disabling the reload of those coefficients allows saving 10ms for each
-measurement and decrease power consumption, while loosing on precision.
+measurement and decrease power consumption, while losing on precision.
Some options may be set directly in the sht15_platform_data structure
or via sysfs attributes.
diff --git a/Documentation/hwmon/zl6100 b/Documentation/hwmon/zl6100
index 756b57c..33908a4 100644
--- a/Documentation/hwmon/zl6100
+++ b/Documentation/hwmon/zl6100
@@ -125,7 +125,7 @@ in2_label "vmon"
in2_input Measured voltage on VMON (ZL2004) or VDRV (ZL9101M,
ZL9117M) pin. Reported voltage is 16x the voltage on the
pin (adjusted internally by the chip).
-in2_lcrit Critical minumum VMON/VDRV Voltage.
+in2_lcrit Critical minimum VMON/VDRV Voltage.
in2_crit Critical maximum VMON/VDRV voltage.
in2_lcrit_alarm VMON/VDRV voltage critical low alarm.
in2_crit_alarm VMON/VDRV voltage critical high alarm.
--
1.8.2.1.342.gfa7285d
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
