Replace clk_enable by clock_enable_prepare and clk_disable with
clk_disable_unprepare.
Clock prepare is required by Clock Common Framework, and old clock driver
didn`t support it.
Without it Common Clock Framework prints a warning.
Signed-off-by: Mateusz Krawczuk <m.krawc...@partner.samsung.com>
---
drivers/media/platform/s5p-tv/sdo_drv.c | 44 +++++++++++++++++++++++++--------
1 file changed, 34 insertions(+), 10 deletions(-)
diff --git a/drivers/media/platform/s5p-tv/sdo_drv.c
b/drivers/media/platform/s5p-tv/sdo_drv.c
index 0afa90f..77eac6d 100644
--- a/drivers/media/platform/s5p-tv/sdo_drv.c
+++ b/drivers/media/platform/s5p-tv/sdo_drv.c
@@ -55,6 +55,8 @@ struct sdo_device {
struct clk *dacphy;
/** clock for control of VPLL */
struct clk *fout_vpll;
+ /** vpll rate before sdo stream was on */
+ int vpll_rate;
/** regulator for SDO IP power */
struct regulator *vdac;
/** regulator for SDO plug detection */
@@ -193,17 +195,34 @@ static int sdo_s_power(struct v4l2_subdev *sd, int on)
static int sdo_streamon(struct sdo_device *sdev)
{
+ int ret = 0;
+
/* set proper clock for Timing Generator */
- clk_set_rate(sdev->fout_vpll, 54000000);
+ sdev->vpll_rate = clk_get_rate(sdev->fout_vpll);
+ ret = clk_set_rate(sdev->fout_vpll, 54000000);
+ if (ret < 0) {
+ dev_err(sdev->dev,
+ "%s: Failed to set vpll rate!\n", __func__);
+ return ret;
+ }
dev_info(sdev->dev, "fout_vpll.rate = %lu\n",
clk_get_rate(sdev->fout_vpll));
/* enable clock in SDO */
sdo_write_mask(sdev, SDO_CLKCON, ~0, SDO_TVOUT_CLOCK_ON);
- clk_enable(sdev->dacphy);
+ ret = clk_prepare_enable(sdev->dacphy);
+ if (ret < 0) {
+ dev_err(sdev->dev,
+ "%s: Failed to prepare and enable clock !\n", __func__);
+ goto fail;
+ }
/* enable DAC */
sdo_write_mask(sdev, SDO_DAC, ~0, SDO_POWER_ON_DAC);
sdo_reg_debug(sdev);
return 0;
+fail:
+ sdo_write_mask(sdev, SDO_CLKCON, 0, SDO_TVOUT_CLOCK_ON);
+ clk_set_rate(sdev->fout_vpll, sdev->vpll_rate);
+ return ret;
}
static int sdo_streamoff(struct sdo_device *sdev)
@@ -211,7 +230,7 @@ static int sdo_streamoff(struct sdo_device *sdev)
int tries;
sdo_write_mask(sdev, SDO_DAC, 0, SDO_POWER_ON_DAC);
- clk_disable(sdev->dacphy);
+ clk_disable_unprepare(sdev->dacphy);
sdo_write_mask(sdev, SDO_CLKCON, 0, SDO_TVOUT_CLOCK_ON);
for (tries = 100; tries; --tries) {
if (sdo_read(sdev, SDO_CLKCON) & SDO_TVOUT_CLOCK_READY)
@@ -220,6 +239,7 @@ static int sdo_streamoff(struct sdo_device *sdev)
}
if (tries == 0)
dev_err(sdev->dev, "failed to stop streaming\n");
+ clk_set_rate(sdev->fout_vpll, sdev->vpll_rate);
return tries ? 0 : -EIO;
}
@@ -254,7 +274,7 @@ static int sdo_runtime_suspend(struct device *dev)
dev_info(dev, "suspend\n");
regulator_disable(sdev->vdet);
regulator_disable(sdev->vdac);
- clk_disable(sdev->sclk_dac);
+ clk_disable_unprepare(sdev->sclk_dac);
return 0;
}
@@ -266,7 +286,7 @@ static int sdo_runtime_resume(struct device *dev)
dev_info(dev, "resume\n");
- ret = clk_enable(sdev->sclk_dac);
+ ret = clk_prepare_enable(sdev->sclk_dac);
if (ret < 0)
return ret;
@@ -299,7 +319,7 @@ static int sdo_runtime_resume(struct device *dev)
vdac_r_dis:
regulator_disable(sdev->vdac);
dac_clk_dis:
- clk_disable(sdev->sclk_dac);
+ clk_disable_unprepare(sdev->sclk_dac);
return ret;
}
@@ -403,10 +423,14 @@ static int sdo_probe(struct platform_device *pdev)
ret = PTR_ERR(sdev->vdet);
goto fail_fout_vpll;
}
-
/* enable gate for dac clock, because mixer uses it */
- clk_enable(sdev->dac);
-
+ clk_prepare_enable(sdev->dac);
+ if (IS_ERR(sdev->dac)) {
+ dev_err(dev,
+ "%s: Failed to prepare and enable clock !\n", __func__);
+ ret = PTR_ERR(sdev->dac);
+ goto fail_fout_vpll;
+ }
/* configure power management */
pm_runtime_enable(dev);
@@ -444,7 +468,7 @@ static int sdo_remove(struct platform_device *pdev)
struct sdo_device *sdev = sd_to_sdev(sd);
pm_runtime_disable(&pdev->dev);
- clk_disable(sdev->dac);
+ clk_disable_unprepare(sdev->dac);
clk_put(sdev->fout_vpll);
clk_put(sdev->dacphy);
clk_put(sdev->dac);
--
1.8.1.2
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
