On Tue, 2014-04-08 at 14:45 +0200, Steffen Trumtrar wrote:
> On Tue, Apr 08, 2014 at 11:45:25AM +0100, Mark Rutland wrote:
> > On Mon, Apr 07, 2014 at 10:54:09PM +0100, ttha...@altera.com wrote:
> > > From: Thor Thayer <ttha...@altera.com>
> > >
> > > Added EDAC support for reporting ECC errors of CycloneV
> > > and ArriaV SDRAM controller.
> > > - The SDRAM Controller registers are used by the FPGA bridge so
> > > these are accessed through the syscon interface.
> > > - The configuration of the SDRAM memory size for the EDAC framework
> > > is discovered from the memory node of the device tree.
> > > - Documentation of the bindings in devicetree/bindings/arm/altera/
> > > socfpga-sdram-edac.txt
> > > - Correction of single bit errors, detection of double bit errors.
> > >
> > > Signed-off-by: Thor Thayer <ttha...@altera.com>
> > > To: Rob Herring <robherri...@gmail.com>
> > > To: Doug Thompson <dougthomp...@xmission.com>
> > > To: Grant Likely <grant.lik...@linaro.org>
> > > Cc: Dinh Nguyen <dingu...@altera.com>
> > > Cc: devicet...@vger.kernel.org
> > > Cc: linux-e...@vger.kernel.org
> > > Cc: linux-kernel@vger.kernel.org
> > > ---
> > > drivers/edac/Kconfig | 9 ++
> > > drivers/edac/Makefile | 2 +
> > > drivers/edac/altera_mc_edac.c | 360
> > > +++++++++++++++++++++++++++++++++++++++++
> > > 3 files changed, 371 insertions(+)
> > > create mode 100644 drivers/edac/altera_mc_edac.c
> >
> > [...]
> >
> > > +/* Get total memory size from Open Firmware DTB */
> > > +static u32 altr_sdram_get_total_mem_size(void)
> > > +{
> > > + struct device_node *np;
> > > + u32 retcode, reg_array[2];
> > > +
> > > + np = of_find_node_by_type(NULL, "memory");
> > > + if (!np)
> > > + return 0;
> > > +
> > > + retcode = of_property_read_u32_array(np, "reg",
> > > + reg_array,
> > > ARRAY_SIZE(reg_array));
> >
> > There's no requirement that #address-cells = <1> or #size-cells = <1>,
> > even if any values in either would fit into 32 bits. If we must read
> > this from the DTB rather than elsewhere, please check
> > of_n_{addr,size}_cells.
> >
> > Additionally, it's possible that the physical memory might be described
> > over multiple reg entries, or multiple memory nodes for some arbitrary
> > reason.
> >
> > Can we not get this info from elsewhere rather than having to parse the
> > memory node within a driver?
> >
>
> It should be possible to calculate this from the dramaddrw register in the
> SDRAM controller.
Thank you all for the comments. I will look into this further.
>
> Regards,
> Steffen
>
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
